Problem s BOOT/LILO

[Jaroslav Lukesh]

> > Na fungujicim RH6/cz (2.2.9) jsem menil nastaveni kernelu, udelal make
> > zImage, make modules, make modules_install, prenesl zImage a System.map
> > do /boot spustil lilo a zrestartoval system.
> > 
> > Objevilo se pouze
> > 
> > LIL-     ( misto spravneho LILO: )
> > 
> > Rescue disketou se na /dev/hda4 dostanu, ale kde co a jak opravit?
> 
> Z dokumentace lila:
> 
> ... it displays L after being started and an O after loading the
> descriptor table and the default command line. Before loading the
> descriptor table, it checks, whether it has been loaded at the correct
> location and displays a question mark if it hasn't. If the descriptor
> table has an incorrect checksum, a minus sign is displayed.
> 
> Takze mate v neporadku tabulku descriptoru, tedy neco se souborem
> /boot/map (pokud me pamet neklame). Opravit by to melo nove spusteni
lila.
> Pro jistotu mozna zkuste nabootovat do single rezimu a zkontrolovat disk
> (preci jenom, soubory se nemrvi sami od sebe).

To jeste nemusi stacit, zkuste taky nastavit spravne parametry harddisku v
biosu (nejlepe autodetect, pokud to setup umi).
Taky zmenit pristupovy mod (access mode DOS, LBA,, Large, other) nekdy
pomuze. Mne disky normalne jedou s DOS (taky zridkakdy jsou vetsi nez
gigo), ale jednou mi nejaky stary kram jel jenom s other.


             Jaroslav Lukesh, K-net

--------------------------------------------------
               http://www.k-net.cz
      Multimedia, Networking, Communications
              Windows terminals, NC
         computer hardware and software
--------------------------------------------------
keep smile :-)
--------------------------------------------------