APC Back UPS 420
Jaroslav Lukesh
lukesh na seznam.cz
Úterý Červenec 4 13:26:15 CEST 2000
Dobry den,
Velmi se omlouvam, ale nevite nekdo nahodou, jak nastavit powerd demona pro
dotycnou UPS? Lidi, co to chteji, mi poslali UPS a samozrejme kabel, ktery
do ni nejde ani strcit.
Takze by mne zajimalo, co dat do powerd.conf:
############# GETTING INFO FROM A SERIAL LINE
#
# If a simple ups asserts a serial line, use the following lines:
# "monitor" DCD or DSR or CTS (pins 8,6,5 on 25-pin and 1,6,8 on 9-pin).
# "failwhen" can be high or low.
# The default is what powerd-1.1 had hardcoded (DCD high means ok).
# ====> Defaults not working, specify them
serialline /dev/cua2
monitor DCD
failwhen low
Staci to tak, nebo je to jinak?
Dekuji
Jaroslav Lukesh, K-net
--------------------------------------------------
http://www.k-net.cz
Multimedia, Networking, Communications
Windows terminals, NC
computer hardware and software
--------------------------------------------------
note: (Bill) Gates to Hell!
Další informace o konferenci Linux