poskozene rozdeleni disku

[LVohralik na csas.cz]

co takhle fdisk /mbr?
prijdete o lilo, ale NT Ok!

			Ladislav Vohralík
			

> From: janso na atlas.cz [mailto:janso na atlas.cz]

> na svem disku jsem mel nasledujici rozdeleni
> 
> hda1 - ntfs
> hda5 - ext2
> hda6 - ext2
> hda7 - linux swap
> 
> nyni fdisk vypise tohle
> ------------------------------------
> Disk /dev/hda: 255 heads, 63 sectors, 527 cylinders
> Units = cylinders of 16065 * 512 bytes
> 
>    Device Boot    Start      End   Blocks   Id  System
> /dev/hda1   ?    115306   236915976827065+  6c  Unknown
> Partition 1 has different physical/logical beginnings (non-Linux?):
>      phys=(80, 10, 0) logical=(115305, 135, 4)
> Partition 1 has different physical/logical endings:
>      phys=(371, 101, 33) logical=(236914, 223, 5)
> Partition 1 does not end on cylinder boundary:
>      phys=(371, 101, 33) should be (371, 254, 63)
> /dev/hda2   ?    120529   208571707199029+  74  Unknown
> Partition 2 has different physical/logical beginnings (non-Linux?):
>      phys=(367, 97, 46) logical=(120528, 70, 23)
> Partition 2 has different physical/logical endings:
>      phys=(370, 104, 37) logical=(208570, 123, 12)
> Partition 2 does not end on cylinder boundary:
>      phys=(370, 104, 37) should be (370, 254, 63)
> /dev/hda3   ?         1        1        0   20  Unknown
> Partition 3 has different physical/logical beginnings (non-Linux?):
>      phys=(288, 68, 18) logical=(0, 0, 33)
> Partition 3 has different physical/logical endings:
>      phys=(32, 32, 32) logical=(0, 0, 32)
> Partition 3 does not end on cylinder boundary:
>      phys=(32, 32, 32) should be (32, 254, 63)
> 
> Disk /dev/hdc: 64 heads, 63 sectors, 787 cylinders
> Units = cylinders of 4032 * 512 bytes
> ---------------------------------
> 
> pokud pouziju fdisk z dosu objevi se informace o 2 oblastech, 
> ktere maji
> velikost -302MB a -2MB
> 
> ---------------------------------
> Jak jsem se k tomuto stavu dostal
> 
> Spatne nakonfigurovanym lilem jsem si prepsal MBR v NT loadrem a o
> opravu jsem se pokusil rescue diskem, ktery se da vyrobit v NT.
> 
> 
> predem dekuji za odpovedi
> 
>                             Jan Sobek
>
>