Ethernet card 3com - eeprom nastaveni

[MUDr. Radek Matlach]

DD,

mam 3com eth combo kartu. Ovladace mam vestavene do jadra a pri bootovani
 se spravne detekuje a hlasi ze nasel zminenou kartu, vypise HW adresu a prida
 hlasku BNC1. A v tom je prave ten problem. Jsem pripojenej prez hub a potrebuju
 pouzivat twistovou zdirku. V archivu jsem nasej jak diagnosticky tak setup
 skript, ale oba vzdycky vychrli jen hromadu cisel, pripadne se sdelenim,
 ze je karta OK, nebo se sdelenim, ze mam zadat, ktere to cislo chci zmenit
 a jak.

Nechci se v tom hned vrtat, takze nevite nekdo jak ma vypadat spravne nastavena
 3com karta aby pouzivala twist. nebo aby si sama zdetekovala kde ma pripojenou
 sit.

Diky Radek

P.S.:
Pro uplnost posilam vyse zmionene vypisy.

Vypis pri startu systemu:
eth0: 3c509 at 0x300 tag 1, BNC port, address  00 a0 24 01 9c 40, IRQ 11.
3c509.c:1.16 (2.2) 2/3/98 becker na cesdis.gsfc.nasa.gov.
eth0: Setting Rx mode to 1 addresses.
-------------------------------------

Vystup z diag3c5x9:
el3diag.c:v0.11 3/16/97 Donald Becker (becker na cesdis.gsfc.nasa.gov)
Looking for card 1.
Generating the activation sequence on port 0x100 for card 1.
Activating the card at I/O address 300.
EEPROM contents:
00a0 2401 9c40 9450 bebf 0036 5a42 6d50 c090 b000 00a0 2401 9c40 0420 0000
 d6c4
An ISA EtherLink III board was activated at I/O 0x300, IRQ 11.
eth0: 3c509 found at 0x300.
Window 0: 6d50 9450 ff01 c090 b000 018f ffff 0002.
Window 1: 00ff 00ff 00fe 2002 8000 00ff 0570 2002.
Window 2: a000 0124 409c 4002 009c 009c 00fe 4002.
Window 3: 0000 000c 0000 6002 ff80 13ff 0573 6002.
Window 4: 0300 00d5 2011 0e84 0002 6810 00fe 8002.
Window 5: 07fe 0600 00fe 07fc 0007 009c 00fe a002.
Window 6: 0000 0000 0000 0000 0000 0000 0000 c002.
Window 7: 009c 009c 00fe e002 009c 009c 00fe e002.
Done card 1.
Looking for card 2.
Generating the activation sequence on port 0x100 for card 2.
Activating the card at I/O address 3f0.
----------------------------------------------

Vystup z setup3c5x9:
3c5x9setup.c:v0.05b 10/6/99 Donald Becker (becker na cesdis.gsfc.nasa.gov)
Interrupt sources are pending.
Adapter Failure indication. 
3c5x9 found at 0x300.
Indication enable is 00fe, interrupt enable is 009c.
------------------------------------------------