Shaper polopate II

[Petr Kincl]

----- Original Message -----
From: "Radek Skokan" <skokan na lanprojekt.cz>
To: <linux na linux.cz>
Sent: Monday, September 18, 2000 12:22 PM
Subject: Re: Shaper polopate II


> >
> > routy
>
> > Zkuste route add -net (host) x.x.x.x .... dev shaper0
>
> > vystrel od pasa: su spravne nastavene routovacie tabulky ?
>
> > no u mna z viacerimi sietovkami je vzdy problem s routovanim :))
> > skus si kuknut ci ti dane siete routuju na tie shapery.
> ============================================
>
> Tim to asi nebude. Kdyz po rebootu nepouziju shapecfg a ifconfigem
nastavim
> rovnou eth0, chodi to a routovaci tabulka vypada stejne jsko se shaperem
(az
> na shaper0 misto eth0). A na pocitaci se pokousim nahodit jen jedno
rozhrani
> s jednou adresou.
>
> RS
>
>
pouzivam vice sitovek a nad jednou omezuji.
Pozivam nasledujici script:

sbin/insmod -o shaper /lib/modules/2.2.14-6.0.1/net/shaper.o
/sbin/insmod -o shaper1 /lib/modules/2.2.14-6.0.1/net/shaper.o

/sbin/shapecfg attach shaper1 eth0
/sbin/shapecfg speed shaper1 65536
/sbin/ifconfig shaper1 192.168.100.2 netmask 255.255.255.0 up
/sbin/route add -net 192.168.239.244 netmask 255.255.255.252 dev shaper1 gw
192.168.100.1

Vsimnete, ze pouzivam shaper1 a nekonfiguruji shaper jako takovy.

Vypis route mam nasledujici:

192.168.239.244 192.168.100.1   255.255.255.252 UG    0      0        0 eth0
192.168.239.244 192.168.100.1   255.255.255.252 UG    2      0        0
shaper1
...
192.168.100.0   0.0.0.0         255.255.255.0   U     0      0        0 eth0
192.168.100.0   0.0.0.0         255.255.255.0   U     0      0        0
shaper1

Jen hadam, jsou spravne metriky?
Petr Kincl