Problem 3C905B a kernel 2.4.6

[AB]

me ta sitovka chodila pod 2.4.5 a chodi i pod 2.4.6 (ve stroji s P100)

"Pavel Ruzicka" <pavouk na nospam.nospam> píse v diskusním príspevku
news:9id8ih$sbi$1 na server4.gts.cz...
> Zdravim.
>
> Po kompilaci kernelu 2.4.6 mi prestala chodit sitovka 3Com 3C905B.
> Pricemz s jadrem 2.4.5 neni nejmensi problem. Zkousel jsem pouzit i starsi
> GCC a take prehrat starsi 3c59x.c z baliku jadra 2.4.5 a problem je stale
> stejny. Take jsem zkousel pouzit funkcni konfiguraci .config z 2.4.5,
abych
> si byl jisty, ze jsem neco nezapomnel zapnout.
>
> Dale davam vypis dmesg a na konci jsou videt chybove hlasky.
> ------------------------------------------------
> Linux version 2.4.6 (root na xxx.xxx.cz) (gcc version 2.96 20000731
> (Linux-Mandrake 8.0 2.96-0.48mdk)) #2 Sun Jul 8 20:56:40 CEST 2001
> PCI: Found IRQ 11 for device 00:0d.0
> 3c59x.c:LK1.1.15 6 June 2001  Donald Becker and others.
> http://www.scyld.com/network/vortex.html
> 00:0d.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xe400,  00:10:4b:6d:41:a2,
> IRQ 11  product code 4e4b rev 00.9 date 03-10-98
>   8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
>   MII transceiver found at address 24, status 786d.
>   Enabling bus-master transmits and whole-frame receives.
> 00:0d.0: scatter/gather enabled. h/w checksums enabled
> eth0: using NWAY device table, not 8
> eth0: command 0x5800 did not complete! Status=0xffff
> eth0: command 0x2800 did not complete! Status=0xffff
> eth0: command 0x3002 did not complete! Status=0xffff
> -------------------------------------------------
>
> Diky za kazdou radu.
>
> Pavouk
>
> mailto: pavouk at comp.cz
>