Nastaveni rychlosti SMC 9332
Zdenek Havelka
madloki na mail.cz
Pondělí Listopad 19 06:49:46 CET 2001
On 18-Nov-2001 cmartin na volny.cz wrote:
> Z toho soudim, ze 100Mbps-FD je rezim ktery by ta katra mela umet ale
> autodetekci se k nemu nepropracuje. Jako ovladac pouzivam modul tulip.o
tulip.o nebude jediny mozny.
find /usr/src/linux/drivers/net -type f -exec fgrep -i "SMC9332" -l {} \;
/usr/src/linux/drivers/net/old_tulip.c
/usr/src/linux/drivers/net/tulip.c
/usr/src/linux/drivers/net/de4x5.c
Ten old_tulip.c vypada, ze umi jen 10Mbit.
Ale u de4x5 je popis:
"""
Command line arguments are now allowed, similar to passing arguments
through LILO. This will allow a per adapter board set up of full duplex
and media. The only lexical constraints are: the board name (dev->name)
appears in the list before its parameters. The list of parameters ends
either at the end of the parameter list or with another board name. The
following parameters are allowed:
fdx for full duplex
autosense to set the media/speed; with the following
sub-parameters:
TP, TP_NW, BNC, AUI, BNC_AUI, 100Mb, 10Mb, AUTO
Case sensitivity is important for the sub-parameters. They *must* be
upper case. Examples:
insmod de4x5 args='eth1:fdx autosense=BNC eth0:autosense=100Mb'.
"""
Tu kartu nemam, ale zkusil bych ten de4x5, a kdyz nic, tak s parametry viz
vyse.
---
Zdenek Havelka
madloki na mail.cz
Další informace o konferenci Linux