prevod z ext2 na ext3 HOTOVO ?
Jiri Kouba
jiri.kouba na volny.cz
Pátek Listopad 30 22:59:48 CET 2001
Minulý mail jsem odeslal předčasně, chci říct tohle:
> > Naopak, mate-li ext3 v jadre, neni initrd vubec potreba.
Právě jsem to vyzkoušel , funguje to.
Jak rozumíte následujícímu pokynu ze stránek Red HAT Supportu ?
Mně to svedlo k tomu, že jsem cestu bez initrd vůbec nezkoušel, měl jsem
initrd nedodělaný a kompilace do jádra to vlastně obešla a zachránila, ovšem
initrd byl vlastně zbytečný.
> ...........
> If you are transitioning your root file system, you will have to use an
> initrd to boot. Run the mkinitrd program as described in the manual and
> make sure that your LILO or GRUB configuration loads the initrd. (If you
> fail to make that change, the system will still boot, but the root file
> system will be mounted as ext2 instead of ext3 - you can tell this by
> looking at the output of the command cat /proc/mounts .) More information
> on tune2fs can be found in the tune2fs man page ( man tune2fs ).
> ..............................
Omlouváme se za protažení tematu, jenže díky tomu je v konferenci
Vaše (Trčkovo) dost kompexní pojednání a převod / by neměl být porblém.
Další informace o konferenci Linux