big HDD = big trouble

[Marian Cavojsky]

On Tue, Sep 18, 2001 at 09:12:53PM +0200, Valter wrote:
 
> > Samozrejme do BIOSu se musi nastavit, ze ten disk nesmi vubec hledat
> 
> Takze, vypol som detekciu v BIOS. Zapojil HDD (zatial do supliku)
> natiahol moduly ide-mod, ide-disk, ide-probe-mod
> 
> Uniform Multi-Platform E-IDE driver Revision: 6.31 
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx 
> PIIX4: IDE controller on PCI bus 00 dev 39 
> PIIX4: chipset revision 1 
> PIIX4: not 100% native mode: will probe irqs later 
> ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio 
> ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio 
> hda: WDC WD400AB-32BVA0, ATA DISK drive 
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 
> hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=77545/16/63,
> UDMA(33) 
> hda: unknown partition table 
> 
> Zatial by to bolo v poriadku. Az na ten posledny riadok.
> fdisk /dev/hda = zamrzne a hlasi lost interrupts
> a to aj ked som cez hdparm nastavil PIO-4 a zakazal vsetky 
> vymozenosti DMA, UDMA, IDE block mode, ...

Skontrolujte najumprovanie disku. Niektore MB s diskami nemaju radi ked
su najumprovane ako master, ale slave tam nie je, alebo skuste vymenit
kabel.

-- 
Marian Cavojsky <cavojsky @ soria-grey.sk>
Spravca siete, Soria & Grey s.r.o, reklamna agentura

Windows&Office jsou jako droga. Krasny a prijemny prvni dojem,
zvyknes si a nemuzes uz bez nich zit.
A pak zacnou prichazet vedlejsi ucinky ...