ATA100 & K7T266 Pro2

[Milan Zidek]

Dne dub 16, Roman DAVID napsal(-a):
> Tady to skutecne vypada, ze ten disk frci v PIO modu.
> Co vam vypise /sbin/hdparm /dev/hda ?
/dev/hda:
 multcount    = 16 (on)
 I/O support  =  3 (32-bit w/sync)
 unmaskirq    =  1 (on)
 using_dma    =  0 (off)
 keepsettings =  0 (off)
 nowerr       =  0 (off)
 readonly     =  0 (off)
 readahead    =  8 (on)
 geometry     = 4865/255/63, sectors = 78165360, start = 0
	 
> pokud:
> ......
> using_dma    =  0 (off)
> ......
> 
> tak jen spuste /sbin/hdparm -d1 /dev/hda
/dev/hda:
 setting using_dma to 1 (on)
 HDIO_SET_DMA failed: Operation not permitted
 using_dma    =  0 (off)

popsal jsem vse v puvodnim mailu

> (pripadne /sbin/hdparm -d1X69 /dev/hda )
/dev/hda:
 setting using_dma to 1 (on)
 HDIO_SET_DMA failed: Operation not permitted
 setting xfermode to 69 (UltraDMA mode5)
 using_dma    =  0 (off)
    
> Melo by to fungovat :-)
Zacinam verit na duchy (proc operace neni povolena? ksanda je spravna a
konektory zapojene taky v poradku podle manualu - barvy)
 

 Milanz