propojit: PC_s_linuxem---eth---PC_s_linuxem , ifconfig , route ... ?

[ondrakr]

Dne ne 21. duben 2002 15:18 jste napsal(a):
> > Pri tom pingu kontrolka vzadu na karte blika ... V cem mam chybu ? Je
 potreba  nejak sitove karte sdelit ktery typ ethernetu ma pouzivat kdyz ma 
BNC i
> > RJ konektor ?
>
> Ano, je to potreba. Kounete do dmesg jaky konektor karta pouziva.

Jak teda nastavim ze ta sitovka ma pouzivat BNC a ne treba RJ ? Pri tom je 
potreba nejaka terminace ? Mam jen kulatej kabel na koncich s BNC myslel sem 
ze to staci.

tak teda:
dmesg | grep eth 
eth0: RealTek RTL-8029 found at 0xe800, IRQ 11, 00:50:FC:37:30

jinak nevim co tam presne jineho hledat posilam to komplet :

Linux version 2.4.18 (root na non) (gcc version 2.96 20000731 (Red Hat Linux 7.2 
2.96-109)) #9 So dub 13 10:11:32 EDT 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000017ff0000 (usable)
 BIOS-e820: 0000000017ff0000 - 0000000017ff3000 (ACPI NVS)
 BIOS-e820: 0000000017ff3000 - 0000000018000000 (ACPI data)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 98288
zone(0): 4096 pages.
zone(1): 94192 pages.
zone(2): 0 pages.
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Kernel command line: ro root=/dev/hda2
Initializing CPU#0
Detected 800.040 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1595.80 BogoMIPS
Memory: 384432k/393152k available (1332k kernel code, 8332k reserved, 373k 
data, 228k init, 0k highmem)
Dentry-cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: Before vendor init, caps: 0183fbff c1c7fbff 00000000, vendor = 2
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
CPU: After vendor init, caps: 0183fbff c1c7fbff 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0183fbff c1c7fbff 00000000 00000000
CPU:             Common caps: 0183fbff c1c7fbff 00000000 00000000
CPU: AMD Duron(tm) Processor stepping 01
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 800.0936 MHz.
..... host bus clock speed is 200.0233 MHz.
cpu: 0, clocks: 2000233, slice: 1000116
CPU0<T0:2000224,T1:1000096,D:12,S:1000116,C:2000233>
mtrr: v1.40 (20010327) Richard Gooch (rgooch na atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb420, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Disabling VIA memory write queue: [55] 89->09
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router VIA [1106/0686] at 00:07.0
Applying VIA southbridge workaround.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
Journalled Block Device driver loaded
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI 
ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
    ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:pio, hdd:DMA
hda: WDC WD300AB-00BVA0, ATA DISK drive
hdd: LTN382, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 58633344 sectors (30020 MB) w/2048KiB Cache, CHS=3649/255/63, UDMA(100)
hdd: ATAPI 40X CD-ROM drive, 120kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda2 hda3 hda4 < hda5 hda6 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256) (6 bit 
encapsulation enabled).
CSLIP: code copyright 1989 Regents of the University of California.
SLIP linefill/keepalive option.
ne2k-pci.c:v1.02 10/19/2000 D. Becker/P. Gortmaker
  http://www.scyld.com/network/ne2k-pci.html
PCI: Found IRQ 11 for device 00:0b.0
PCI: Sharing IRQ 11 with 00:07.2
PCI: Sharing IRQ 11 with 00:07.3
eth0: RealTek RTL-8029 found at 0xe800, IRQ 11, 00:50:FC:37:30:D4.
PPP generic driver version 2.4.1
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 321M
agpgart: Detected Via Apollo Pro KT133 chipset
agpgart: AGP aperture is 64M @ 0xd0000000
Via 686a audio driver 1.9.1
PCI: Found IRQ 5 for device 00:07.5
ac97_codec: AC97 Audio codec, id: 0x4943:0x4511 (ICE1232)
via82cxxx: board #1 at 0xDC00, IRQ 5
es1371: version v0.30 time 21:32:40 Apr  7 2002
usb.c: registered new driver hub
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 11 for device 00:07.2
PCI: Sharing IRQ 11 with 00:07.3
PCI: Sharing IRQ 11 with 00:0b.0
uhci.c: USB UHCI at I/O 0xd400, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 11 for device 00:07.3
PCI: Sharing IRQ 11 with 00:07.2
PCI: Sharing IRQ 11 with 00:0b.0
uhci.c: USB UHCI at I/O 0xd800, IRQ 11
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 32768)
IPv4 over IPv4 tunneling driver
GRE over IPv4 tunneling driver
ip_conntrack (3071 buckets, 24568 max)
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 228k freed
Adding Swap: 803240k swap-space (priority -1)
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,2), internal journal
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,5), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,6), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Disk change detected on device ide1(22,64)
hdd: DMA disabled
parport0: PC-style at 0x378 [PCSPP(,...)]
parport_pc: Via 686A parallel port: io=0x378
spurious 8259A interrupt: IRQ7.
nvidia: loading NVIDIA NVdriver Kernel Module  1.0-2802  Tue Mar  5 06:26:45 
PST 2002
NVRM: AGPGART: VIA Apollo KT133 chipset
NVRM: AGPGART: aperture: 64M @ 0xd0000000
NVRM: AGPGART: aperture mapped from 0xd0000000 to 0xd99d0000
NVRM: AGPGART: mode 2x
NVRM: AGPGART: allocated 16 pages