ATA100 & K7T266 Pro2

[Milan Zidek]

Dne dub 22, Jan Houstek napsal(-a):
> Co vypise hdparm /dev/hda
/dev/hda:
 multcount    = 16 (on)
 I/O support  =  1 (32-bit)
 unmaskirq    =  1 (on)
 using_dma    =  0 (off)
 keepsettings =  0 (off)
 nowerr       =  0 (off)
 readonly     =  0 (off)
 readahead    =  8 (on)
 geometry     = 4865/255/63, sectors = 78165360, start = 0
	 
dma prokazatelne vypnuto :-(

> hdparm -i /dev/hda
/dev/hda:

 Model=ST340016A, FwRev=3.10, SerialNo=3HS2JFAN
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=unknown, BuffSize=2048kB, MaxMultSect=16, MultSect=16
 CurCHS=4047/16/255, CurSects=-217054981, LBA=yes,
 LBAsects=78165360
 IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes: pio0 pio1 pio2 pio3 pio4 
 DMA modes: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5 
 AdvancedPM=no
 Drive Supports : Reserved : ATA-1 ATA-2 ATA-3 ATA-4 ATA-5 

udma5 je podle me nastaveno (nebo alespon by melo jit nastavit)

> Jaky je kernel
2.4.7-10

> a co se ohledne disku pise v dmesg?
pouze to co uz jsem psal v uvodnim prispevku (i k MB)
  VP_IDE: Unknown VIA SouthBridge, contact Vojtech Pavlik <v...
  VP_IDE: ATA-66/100 forced bit set (WARNING)!!
  hda: ST340016A, ATA DISK drive
  ide0 at 0x1f0-0x1f7,0x3f6 on irq 14                                                    ide0: probed IRQ 14 failed, using default.
  hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63

No podle toho ci jsem si tady precetl, budu kompilovat jadro (cekam jen
na novou grafiku - kdyz uz se v tom budu hrabat... ")
 

Zatim diky vsem

	Mlanz