Nefungujici vypalovani na nektere CD-RW media.

[martin.kula na deltaes.cz]

Zdravim !

Na vypalovacce Yamaha CRW8424S, se kterou jsem nikdy nemel problemy
namohu vypalit CD-RW media Verbatim Hi-Speed 4x-10x. Pritom na jine CD-RW 
medium Yamaha 74R4X funguje vypalovani bez problemu, zrovna tak na 
jakekoli CD-R media.
Nevite nekdo v cem by mohl byt problem, kdyz jinak funguje vse OK.
(Zkousel jsem to na dve shodne media Verbatim - obe uplne nove !!)

Dik za jakekoli napady.

Martin

cdrecord vypise nasledujici:
Pri pokusu o vypaleni dat:
--------------------------------------------------------
scsidev: '0,1,0'
scsibus: 0 target: 1 lun: 0
Linux sg driver version: 3.1.19
Cdrecord 1.10 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.5'
atapi: 0
Device type    : Removable CD-ROM
Version        : 2
Response Format: 2
Capabilities   : SYNC 
Vendor_info    : 'YAMAHA  '
Identifikation : 'CRW8424S        '
Revision       : '1.0f'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags   : SWABAUDIO
Drive buf size : 3172848 = 3098 KB
FIFO size      : 4194304 = 4096 KB
Track 01: data  617 MB        
Total size:     709 MB (70:17.54) = 316316 sectors
Lout start:     709 MB (70:19/41) = 316316 sectors
Current Secsize: 512
ATIP info from disk:
  Indicated writing power: 2
  Reference speed: 6
  Is not unrestricted
  Is erasable
  Disk sub type: High speed Rewritable (CAV) media (1)
  ATIP start of lead in:  -11077 (97:34/23)
  ATIP start of lead out: 336075 (74:43/00)
  speed low: 4 speed high: 8
  power mult factor: 2 6
  recommended erase/write power: 5
  A2 values: 14 A4 4A
Disk type:    Phase change
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 336075 Blocks current: 336075 Blocks remaining: 19759
Starting to write CD/DVD at speed 4 in write mode for single session.
Last chance to quit, starting real write in 9 seconds.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
cdrecord: Input/output error. send opc: scsi sendcmd: no error
CDB:  54 01 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 06 00 00 00 00 0A 00 00 00 00 29 00 00 00
Sense Key: 0x6 Unit Attention, Segment 0
Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0
Sense flags: Blk 0 (not valid) 
cmd finished after 62.517s timeout 60s
cdrecord: Resource temporarily unavailable. OPC failed.
cdrecord: Input/output error. prevent/allow medium removal: scsi sendcmd: no error
CDB:  1E 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 02 00 00 00 00 0A 00 00 00 00 04 01 00 00
Sense Key: 0x2 Not Ready, Segment 0
Sense Code: 0x04 Qual 0x01 (logical unit is in process of becoming ready) Fru 0x0
Sense flags: Blk 0 (not valid) 
cmd finished after 0.012s timeout 40s
cdrecord: fifo had 64 puts and 0 gets.
cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
-----------------------------------------------------------------------
a pri pokusu o blank
-----------------------------------------------------------------------
scsidev: '0,1,0'
scsibus: 0 target: 1 lun: 0
Linux sg driver version: 3.1.19
Cdrecord 1.10 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.5'
atapi: 0
Device type    : Removable CD-ROM
Version        : 2
Response Format: 2
Capabilities   : SYNC 
Vendor_info    : 'YAMAHA  '
Identifikation : 'CRW8424S        '
Revision       : '1.0f'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags   : SWABAUDIO
Drive buf size : 3172848 = 3098 KB
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 2
  Reference speed: 6
  Is not unrestricted
  Is erasable
  Disk sub type: High speed Rewritable (CAV) media (1)
  ATIP start of lead in:  -11077 (97:34/23)
  ATIP start of lead out: 336075 (74:43/00)
  speed low: 4 speed high: 8
  power mult factor: 2 6
  recommended erase/write power: 5
  A2 values: 14 A4 4A
Disk type:    Phase change
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 336075 Blocks current: 336075 Blocks remaining: 336225
Starting to write CD/DVD at speed 4 in write mode for single session.
Last chance to quit, starting real write in 9 seconds.
Blanking PMA, TOC, pregap
cdrecord: Input/output error. blank unit: scsi sendcmd: no error
CDB:  A1 01 00 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 04 83 EC 99 ED 0A 00 00 00 00 09 00 00 00
Sense Key: 0x4 Hardware Error, Segment 0
Sense Code: 0x09 Qual 0x00 (track following error) Fru 0x0
Sense flags: Blk -2081646099 (not valid) 
cmd finished after 72.342s timeout 9600s
cdrecord: Cannot blank disk, aborting.
----------------------------------------------------------------------