mplayer a pretizeni CPU
Petr Šobáň
soban na centrum.cz
Neděle Srpen 10 02:53:53 CEST 2003
Dne ne 10. srpna 2003 00:53 jste napsal(a):
> Dobry den,
>
> mplayer mi po startu napsal:
>
> ---------------------------------------------------------------------------
>---------- MPlayer 0.90-RPM-3.1 (C) 2000-2003 Arpad Gereoffy (see DOCS)
>
> CPU: Advanced Micro Devices Athlon 4 PM Palomino/Athlon MP
> Multiprocessor/Athlon XP eXtreme Performance (Family: 6, Stepping: 2)
> Detected cache-line size is 64 bytes
> CPUflags: MMX: 1 MMX2: 1 3DNow: 1 3DNow2: 1 SSE: 1 SSE2: 0
> Compiled with Runtime CPU Detection - WARNING - this is not optimal!
> To get best performance, recompile MPlayer with
> --disable-runtime-cpudetection
> ---------------------------------------------------------------------------
>----------
>
> tak jsem tedy udelal:
> make clean
> ./configure --disable-runtime-cpudetection --enable-gui
> make
> make install
Taky se mi to ruzně šprajcovalo a tak jsem si hral s parametrama a uz nevim co
jsem tam presne zadal ale vím že jsem zakázal SSE na tvrdo při konfiguraci a
potom to neblblo. A XP 1700+
Výtah z config.h
/* Extension defines */
#define HAVE_3DNOW 1 // only define if you have 3DNOW (AMD k6-2, AMD Athlon,
iDT WinChip, etc.)
#define HAVE_3DNOWEX 1 // only define if you have 3DNOWEX (AMD Athlon, etc.)
#define HAVE_MMX 1 // only define if you have MMX (newer x86 chips, not
P54C/PPro)
#define HAVE_MMX2 1 // only define if you have MMX2 (Athlon/PIII/4/CelII)
#undef HAVE_SSE // only define if you have SSE (Intel Pentium III/4 or Celeron
II)
#undef HAVE_SSE2 // only define if you have SSE2 (Intel Pentium 4)
#undef HAVE_ALTIVEC // only define if you have Altivec (G4)
--
/----------------------------------------\
| Petr Šobáň |
| Olomouc |
|----------------------------------------|
| e-mail soban na centrum.cz |
| jabber soban na jabber.cz |
| ICQ 179223500 |
\----------------------------------------/
Další informace o konferenci Linux