problemy s HDD - ze by odchazel?

Libor Kuffa kuffa na centrum.cz
Čtvrtek Červen 5 11:00:53 CEST 2003


Tak tady jsou S.M.A.R.T. reporty z obou disku:

hdc:

smartctl version 5.1-9 Copyright (C) 2002-3 Bruce Allen
Home page is http://smartmontools.sourceforge.net/

=== START OF INFORMATION SECTION ===
Device Model:     ST340810A                               
Serial Number:    6FB1Y3V8            
Firmware Version: 3.39    
ATA Version is:   6
ATA Standard is:  Unrecognized. Minor revision code: 0x00
Local Time is:    Wed Jun  4 23:51:40 2003 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Off-line data collection status: (0x82)	Offline data collection activity
					completed without error.
Self-test execution status:      (   0)	The previous self-test routine
completed
					without error or no self-test has ever 
					been run.
Total time to complete off-line 
data collection: 		 ( 420) seconds.
Offline data collection
capabilities: 			 (0x1d) SMART execute Offline immediate.
					No Automatic timer ON/OFF support.
					Abort Offline collection upon new
					command.
					Offline surface scan supported.
					Self-test supported.
SMART capabilities:            (0x0003)	Saves SMART data before entering
					power-saving mode.
					Supports SMART auto save timer.
Error logging capability:        (0x01)	Error logging supported.
Short self-test routine 
recommended polling time: 	 (   1) minutes.
Extended self-test routine 
recommended polling time: 	 (  42) minutes.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE    
WHEN_FAILED RAW_VALUE
  1 Raw_Read_Error_Rate     0x000f   070   063   025    Pre-fail    
-       173859635
  3 Spin_Up_Time            0x0003   098   098   000    Pre-fail    
-       0
  4 Start_Stop_Count        0x0032   100   100   020    Old_age     
-       21
  5 Reallocated_Sector_Ct   0x0033   100   100   036    Pre-fail    
-       2
  7 Seek_Error_Rate         0x000f   068   060   030    Pre-fail    
-       17205815313
  9 Power_On_Hours          0x0032   100   100   000    Old_age     
-       719
 10 Spin_Retry_Count        0x0013   100   100   097    Pre-fail    
-       0
 12 Power_Cycle_Count       0x0032   100   100   020    Old_age     
-       461
194 Temperature_Celsius     0x0022   035   054   000    Old_age     
-       35
195 Hardware_ECC_Recovered  0x001a   100   253   000    Old_age     
-       0
197 Current_Pending_Sector  0x0012   100   100   000    Old_age     
-       0
198 Offline_Uncorrectable   0x0010   100   100   000    Old_age     
-       0
199 UDMA_CRC_Error_Count    0x003e   200   177   000    Old_age     
-       307
200 Multi_Zone_Error_Rate   0x0000   100   253   000    Old_age     
-       0
202 Unknown_Attribute       0x0032   100   253   000    Old_age     
-       0

SMART Error Log Version: 1
ATA Error Count: 326 (device log contains only the most recent five
errors)
	DCR = Device Control Register
	FR  = Features Register
	SC  = Sector Count Register
	SN  = Sector Number Register
	CL  = Cylinder Low Register
	CH  = Cylinder High Register
	D/H = Device/Head Register
	CR  = Content written to Command Register
	ER  = Error register
	STA = Status register
Timestamp is seconds since the previous disk power-on.
Note: timestamp "wraps" after 2^32 msec = 49.710 days.

Error 326 occurred at disk power-on lifetime: 180 hours
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER:84 SC:00 SN:3f CL:03 CH:00 D/H:e0 ST:51
Sequence of commands leading to the command that caused the error were:
DCR   FR   SC   SN   CL   CH   D/H   CR   Timestamp
 00   00   08   3f   03   00    e0   c8     1.036
 00   00   08   3f   03   00    e0   c8     2.363
 00   00   08   3f   03   00    e0   c8     26.286
 00   00   08   37   03   00    e0   c8     18.792
 00   00   08   2f   03   00    e0   c8     0.793

Error 325 occurred at disk power-on lifetime: 180 hours
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER:84 SC:00 SN:3f CL:03 CH:00 D/H:e0 ST:51
Sequence of commands leading to the command that caused the error were:
DCR   FR   SC   SN   CL   CH   D/H   CR   Timestamp
 00   00   08   3f   03   00    e0   c8     1.107
 00   00   08   3f   03   00    e0   c8     26.286
 00   00   08   37   03   00    e0   c8     18.792
 00   00   08   2f   03   00    e0   c8     0.793
 00   00   01   00   00   00    e0   c8     10.022

Error 324 occurred at disk power-on lifetime: 180 hours
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER:84 SC:00 SN:3f CL:03 CH:00 D/H:e0 ST:51
Sequence of commands leading to the command that caused the error were:
DCR   FR   SC   SN   CL   CH   D/H   CR   Timestamp
 00   00   08   3f   03   00    e0   c8     1.076
 00   00   08   37   03   00    e0   c8     18.792
 00   00   08   2f   03   00    e0   c8     0.793
 00   00   01   00   00   00    e0   c8     10.022
 00   00   01   00   00   00    a0   ec     1.121

Error 323 occurred at disk power-on lifetime: 180 hours
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER:84 SC:00 SN:3f CL:03 CH:00 D/H:e0 ST:51
Sequence of commands leading to the command that caused the error were:
DCR   FR   SC   SN   CL   CH   D/H   CR   Timestamp
 00   00   08   37   03   00    e0   c8     18.792
 00   00   08   2f   03   00    e0   c8     0.793
 00   00   01   00   00   00    e0   c8     10.022
 00   00   01   00   00   00    a0   ec     1.121
 00   00   01   00   00   00    e0   c8     5.765

Error 322 occurred at disk power-on lifetime: 180 hours
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER:84 SC:00 SN:37 CL:03 CH:00 D/H:e0 ST:51
Sequence of commands leading to the command that caused the error were:
DCR   FR   SC   SN   CL   CH   D/H   CR   Timestamp
 00   00   08   2f   03   00    e0   c8     0.793
 00   00   01   00   00   00    e0   c8     10.022
 00   00   01   00   00   00    a0   ec     1.121
 00   00   01   00   00   00    e0   c8     5.765
 00   00   01   00   00   00    a0   ec     1.225

SMART Self-test log, version number 1
Num  Test_Description    Status                  Remaining 
LifeTime(hours)  LBA_of_first_error
# 1  Short off-line      Completed                     00%      
589         -

a hdd:

smartctl version 5.1-9 Copyright (C) 2002-3 Bruce Allen
Home page is http://smartmontools.sourceforge.net/

=== START OF INFORMATION SECTION ===
Device Model:     QUANTUM FIREBALLP AS20.5                
Serial Number:    892031772743        
Firmware Version: A1Y.1300
ATA Version is:   5
ATA Standard is:  ATA/ATAPI-5 T13 1321D revision 1
Local Time is:    Wed Jun  4 23:50:41 2003 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Off-line data collection status: (0x00)	Offline data collection activity
was
					never started.
Self-test execution status:      (  16)	The self-test routine was
aborted by
					the host.
Total time to complete off-line 
data collection: 		 (  34) seconds.
Offline data collection
capabilities: 			 (0x1b) SMART execute Offline immediate.
					Automatic timer ON/OFF support.
					Suspend Offline collection upon new
					command.
					Offline surface scan supported.
					Self-test supported.
SMART capabilities:            (0x0003)	Saves SMART data before entering
					power-saving mode.
					Supports SMART auto save timer.
Error logging capability:        (0x00)	Error logging NOT supported.
Short self-test routine 
recommended polling time: 	 (   2) minutes.
Extended self-test routine 
recommended polling time: 	 (  13) minutes.

SMART Attributes Data Structure revision number: 11
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE    
WHEN_FAILED RAW_VALUE
  1 Raw_Read_Error_Rate     0x0029   100   253   020    Pre-fail    
-       0
  3 Spin_Up_Time            0x0027   086   079   020    Pre-fail    
-       1804
  4 Start_Stop_Count        0x0032   098   098   008    Old_age     
-       1449
  5 Reallocated_Sector_Ct   0x0033   100   100   020    Pre-fail    
-       0
  7 Seek_Error_Rate         0x000b   100   100   023    Pre-fail    
-       0
  9 Power_On_Hours          0x0012   099   099   001    Old_age     
-       1178
 10 Spin_Retry_Count        0x0026   100   100   000    Old_age     
-       0
 11 Calibration_Retry_Count 0x0013   100   100   020    Pre-fail    
-       0
 12 Power_Cycle_Count       0x0032   098   098   008    Old_age     
-       1394
 13 Read_Soft_Error_Rate    0x000b   100   100   023    Pre-fail    
-       0
195 Hardware_ECC_Recovered  0x001a   082   013   000    Old_age     
-       3720189
196 Reallocated_Event_Count 0x0010   100   100   020    Old_age     
-       0
197 Current_Pending_Sector  0x0032   100   100   020    Old_age     
-       0
198 Offline_Uncorrectable   0x0010   100   253   000    Old_age     
-       0
199 UDMA_CRC_Error_Count    0x001a   001   001   000    Old_age     
-       530

Warning: device does not support Error Logging
SMART Error Log Version: 0
No Errors Logged

Warning: device does not support Self Test Logging





Další informace o konferenci Linux