padajici GPRS spojeni
David 'Ilicz' Klementa
ilicz na seznam.cz
Čtvrtek Září 16 09:46:27 CEST 2004
S Bluezem ti neporadim, ale mam GPRS na SE T610 (hrnu pres IrDA a beha
mi to...
Ty ctyri soubory co jsou v priloze nacpes do /etc/ppp/peers
v /etc/modules.conf pridas radku
options ppp_async flag_time=0
pak jeste musis zaexperimentovat s nastavenim lcp-echo-failure a
lcp-echo-interval
taky mi to vypadavalo, ale kdyz jsem nastavil v /etc/ppp/options
lcp-echo-interval 30
lcp-echo-failure 4
Good Luck.. <ilicz>
pat wrote:
> Ahoj,
>
> tak je tu pokracovani story :-\ Telefon jsem dal do opravy a dostal nahradni
> (SonyEricsson T68i), bohuzel ten se chova naprosto stejnym zpusobem :-((( 30
> vterin a dost.
>
> Muze mi prosim nekdo napsat resnou konfiguraci, ktera mu funguje ??? Kernel,
> BlueZ, patches, HW, telefon atd. ??? Celkem by to pomohlo. Uz toho zacinam mit
> tak akorat :-\
>
> Diky moc.
>
> Pat
>
--
David 'ilicz' Klementa
GSM: +420 721 811 539
ICQ: #137287977
mail: ilicz(zavinac)seznam(tecka)cz
----------
* www.inMail.cz - Vase emailova adresa na cely zivot ZDARMA
* www.czechia.com - profesionalni webhosting a registrace domen za vyhodne ceny
* Zoner Media Explorer 6 - Poznejte kouzlo digitální fotografie! (http://www.zoner.cz/zme6)
* www.ZonerPress.cz - pocitacova literatura, zamereni na webdesign a grafiku
------------- další část ---------------
# $Id: gprs,v 1.4 2004/04/28 08:40:32 mcfrisk Exp $
#
# File:
# gprs
#
# Description:
# Serial cable, IrDA, Bluetooth and USB pppd options for GPRS phones.
# See 'man pppd' for detailed option descriptions.
# Most GPRS phones don't reply to LCP echo's
lcp-echo-failure 0
lcp-echo-interval 0
# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach
# Debug info from pppd:
# Comment this off, if you don't need more info
debug
# Show password in debug messages
show-password
# Connect script:
# scripts to initialize the GPRS modem and start the connection,
# wvdial command is for Orange SPV while other phones should work with chat
connect /etc/ppp/peers/gprs-connect-chat
#connect "/usr/bin/wvdial --chat --config /etc/ppp/peers/gprs-wvdial.conf radiolinja_usb_orange_spv"
# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/peers/gprs-disconnect-chat
# Serial device to which the GPRS phone is connected:
# /dev/ttyS0 for serial port (COM1 in Windows),
# /dev/ircomm0 for IrDA,
# /dev/ttyUB0 for Bluetooth (Bluez with rfcomm running) and
# /dev/ttyUSB0 for USB
#/dev/ttyS0 # serial port one
#/dev/ttyS1 # serial port two
/dev/ircomm0 # IrDA serial port one
#/dev/rfcomm0 # Bluetooth serial port one
#/dev/ttyUSB0 # USB serial device, for example Orange SPV
# Serial port line speed
115200 # fast enough
#57600 # perhaps usefull with IrDA as some phones don't like
# speeds higher than this
# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
crtscts # serial cable, Bluetooth and USB, on some occations with IrDA too
#nocrtscts # IrDA
# Ignore carrier detect signal from the modem:
local
# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else
:10.0.0.1
# pppd must not propose any IP address to the peer!
noipdefault
# Accept peers idea of our local address
ipcp-accept-local
# Add the ppp interface as default route to the IP routing table
defaultroute
# Newer pppd's also support replacing the default route, if one is
# already present, when the GPRS connetion should be set as the default route
# to the network
#replacedefaultroute
# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns
# ppp compression:
# ppp compression may be used between the phone and the pppd, but the
# serial connection is usually not the bottleneck in GPRS, so the
# compression is useless (and with some phones need to disabled before
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp
# The phone is not required to authenticate:
noauth
# Username and password:
# If username and password are required by the APN, put here the username
# and put the username-password combination to the secrets file:
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP
# authentication. See pppd man pages for details.
# Example, Radiolinja operator pap-secrets:
# "rlnet" * "internet" *
user "rlnet"
# The persist tries to reopen the connection if it is dropped. This
# is usefull for example with a Nokia 7650 which only manages to
# 'dial' with every second attempt or when the network likes to drop the
# connection every now and then. It's not fun when the over-night
# 'apt-get dist-upgrade -d -y' fails constantly...
#persist
#maxfail 99
# Asyncmap:
# some phones may require this option.
#asyncmap 0xa0000
# No magic:
# some phones may require this option.
#nomagic
# Require PAP authentication:
# some phones may require this option.
#require-pap
----------
* www.inMail.cz - Vase emailova adresa na cely zivot ZDARMA
* www.czechia.com - profesionalni webhosting a registrace domen za vyhodne ceny
* Zoner Media Explorer 6 - Poznejte kouzlo digitální fotografie! (http://www.zoner.cz/zme6)
* www.ZonerPress.cz - pocitacova literatura, zamereni na webdesign a grafiku
------------- další část ---------------
#!/bin/sh
#
# $Id: gprs-connect-chat,v 1.2 2004/02/02 23:19:28 mcfrisk Exp $
#
# File:
# gprs-connect-chat
#
# Description:
# chat script to open Radiolinjas GPRS service with GPRS phones. If ppp
# negotiation stalls, try restarting the phone. To try with other GPRS
# operator setting, change the PDP contex setting. The settings work with
# most Ericsson models, but Nokia 8310 and 30 do not support QoS parameters
# with AT commands, so just delete those lines and it'll work.
#
# Set PDP context CID=1, protocol=IP, APN=internet:
# AT+CGDCONT=1,"IP","internet","",0,0
#
# Set CID=1 QoS requirements from the network, not supported by Nokia:
# AT+CGQREQ=1,0,0,0,0,0
#
# Set CID=1 minimum acceptable QoS parameters, not supported by Nokia:
# AT+CGQMIN=1,0,0,0,0,0
#
# 'Call' CID=1 (activate PDP context one, perform GPRS attach):
# ATD*99***1#
#
# Some phones like the Orange SPV (yes, the Microsoft Smartphone) use this
# dial string to start GPRS connection:
# ATD*99#
#
# The actual chat script:
exec chat \
TIMEOUT 5 \
ECHO ON \
ABORT '\nBUSY\r' \
ABORT '\nERROR\r' \
ABORT '\nNO ANSWER\r' \
ABORT '\nNO CARRIER\r' \
ABORT '\nNO DIALTONE\r' \
ABORT '\nRINGING\r\n\r\nRINGING\r' \
'' \rAT \
TIMEOUT 12 \
SAY "Press CTRL-C to close the connection at any stage!" \
SAY "\ndefining PDP context...\n" \
OK ATH \
OK ATE1 \
OK 'AT+CGDCONT=1,"IP","internet","",0,0' \
OK ATD*99***1# \
TIMEOUT 22 \
SAY "\nwaiting for connect...\n" \
CONNECT "" \
SAY "\nConnected." \
SAY "\nIf the following ppp negotiations fail,\n" \
SAY "try restarting the phone.\n"
----------
* www.inMail.cz - Vase emailova adresa na cely zivot ZDARMA
* www.czechia.com - profesionalni webhosting a registrace domen za vyhodne ceny
* Zoner Media Explorer 6 - Poznejte kouzlo digitální fotografie! (http://www.zoner.cz/zme6)
* www.ZonerPress.cz - pocitacova literatura, zamereni na webdesign a grafiku
------------- další část ---------------
#!/bin/sh
#
# $Id: gprs-disconnect-chat,v 1.2 2004/02/02 23:19:28 mcfrisk Exp $
#
# File:
# gprs-disconnect-chat
#
# send break
exec /usr/sbin/chat -V -s -S \
ABORT "BUSY" \
ABORT "ERROR" \
ABORT "NO DIALTONE" \
SAY "\nSending break to the modem\n" \
"" "\K" \
"" "+++ATH" \
SAY "\nPDP context detached\n"
----------
* www.inMail.cz - Vase emailova adresa na cely zivot ZDARMA
* www.czechia.com - profesionalni webhosting a registrace domen za vyhodne ceny
* Zoner Media Explorer 6 - Poznejte kouzlo digitální fotografie! (http://www.zoner.cz/zme6)
* www.ZonerPress.cz - pocitacova literatura, zamereni na webdesign a grafiku
------------- další část ---------------
# File:
#
# $Id: gprs-wvdial.conf,v 1.3 2004/04/27 21:44:35 mcfrisk Exp $
#
# gprs-wvdial.conf
#
# Description:
# Wvdial settings for different GPRS phones and operators. See wvdial man pages
# for more help. Below are the service specific settings, which should be given
# by the operator - at least the
#
# Set PDP (Packet Data Protocol) context CID (Context ID) = 1 (an index sort of
# since a phone may have many different GPRS settings), protocol = IP,
# APN (Access Point Name) = "internet":
# AT+CGDCONT=1,"IP","internet","",0,0
#
# Set CID=1 QoS (Quality of Service) requirements from the network, not
# supported by Nokia phones:
# AT+CGQREQ=1,0,0,0,0,0
#
# Set CID=1 minimum acceptable QoS parameters, not supported by Nokia phones:
# AT+CGQMIN=1,0,0,0,0,0
#
# Call CID=1 which activate PDP context one and perform GPRS attach:
# ATD*99***1#
#
# Some phones seem to have only one CID, in which case the CID can be omitted
# when calling:
# ATD*99#
#
# Init4 = AT+CGQREQ=1,0,0,0,0,0
# Init5 = AT+CGQMIN=1,0,0,0,0,0
[Dialer radiolinja_usb_orange_spv]
#Modem = /dev/ttyUSB0
#Baud = 115200
Init1 = ATH
Init2 = ATE1
Init3 = AT+CGDCONT=1,"IP","internet"
# Some phones like the NEC DB7000 don't like empty strings, so an address must
# be provided
#Init3 = AT+CGDCONT=1,"IP","internet","0.0.0.0",0,0
# Some phones don't like the quality of service parameters:
# Init4 = AT+CGQREQ=1,0,0,0,0,0
# Init5 = AT+CGQMIN=1,0,0,0,0,0
Dial Command = ATD
#Phone = *99#
Phone = ATD*99***1#
Username = rlnet
Password = internet
----------
* www.inMail.cz - Vase emailova adresa na cely zivot ZDARMA
* www.czechia.com - profesionalni webhosting a registrace domen za vyhodne ceny
* Zoner Media Explorer 6 - Poznejte kouzlo digitální fotografie! (http://www.zoner.cz/zme6)
* www.ZonerPress.cz - pocitacova literatura, zamereni na webdesign a grafiku
Další informace o konferenci Linux