t-mobile 4g - jak na to

=?UTF-8?Q?Michal_Ka=B9par?= mkaspar na it-media.cz
Sobota Listopad 5 19:24:45 CET 2005


On Sat, Nov 05, 2005 at 04:46:39PM +0100, Michal Janda wrote:
> Zdravím,
> chová se to jako normální ADSL, takže třeba v mandrivě se to dá i 
> naklikat - vyberte ADSL, Česká republika a mělo by to fungovat.

Teď jsem zkoušel variantu s Ethernetem (PPPoE) a přes Debianí pppoeconf,
kde sem v podstatě všechno odklikal jako default to bez problému jede.
Přikládám /etc/ppp/peers/dsl-provider, který to vygenerovalo.
Návod pro usb verzi je na
http://www.abclinuxu.cz/hardware/show/106474;jsessionid=23u0i18mjf6r8

-- 
Michal Kašpar
------------- další část ---------------
# Configuration file for PPP, using PPP over Ethernet 
# to connect to a DSL provider.
#
# See the manual page pppd(8) for information on all the options.

##
# Section 1
#
# Stuff to configure...

# MUST CHANGE: Uncomment the following line, replacing the user na provider.net
# by the DSL user name given to your by your DSL provider.
# (There should be a matching entry in /etc/ppp/pap-secrets with the password.)
#user myusername na myprovider.net

# Use the pppoe program to send the ppp packets over the Ethernet link
# This line should work fine if this computer is the only one accessing
# the Internet through this DSL connection. This is the right line to use
# for most people.
#pty "/usr/sbin/pppoe -I eth0 -T 80 -m 1452"

# An even more conservative version of the previous line, if things
# don't work using -m 1452... 
#pty "/usr/sbin/pppoe -I eth0 -T 80 -m 1412"

# If the computer connected to the Internet using pppoe is not being used
# by other computers as a gateway to the Internet, you can try the following
# line instead, for a small gain in speed:
#pty "/usr/sbin/pppoe -I eth0 -T 80"


# The following two options should work fine for most DSL users.

# Assumes that your IP address is allocated dynamically
# by your DSL provider...
noipdefault
# Try to get the name server addresses from the ISP.
usepeerdns
# Use this connection as the default route.
# Comment out if you already have the correct default route installed.
defaultroute

##
# Section 2
#
# Uncomment if your DSL provider charges by minute connected
# and you want to use demand-dialing. 
#
# Disconnect after 300 seconds (5 minutes) of idle time.

#demand
#idle 300

##
# Section 3
#
# You shouldn't need to change these options...

hide-password
lcp-echo-interval 20
lcp-echo-failure 3
# Override any connect script that may have been set in /etc/ppp/options.
connect /bin/true
noauth
persist
mtu 1492

# RFC 2516, paragraph 7 mandates that the following options MUST NOT be
# requested and MUST be rejected if requested by the peer:
# Address-and-Control-Field-Compression (ACFC)
noaccomp
# Asynchronous-Control-Character-Map (ACCM)
default-asyncmap

plugin rp-pppoe.so eth0
user "gprs"


Další informace o konferenci Linux