Stopování HW chyb - hdl: dma_timer_expiry: dma status == 0x61, end_request: I/O error, dev hdl, sector 305100095
Dan Ohnesorg
Dan na feld.cvut.cz
Středa Leden 18 11:48:52 CET 2006
Dne Tue, Jan 17, 2006 at 07:38:10PM +0100, n_petr na seznam.cz napsal:
> Ahoj,
> co si myslíte o tomto logu z dmesg?
>
> hdl: dma_timer_expiry: dma status == 0x61
> hdl: DMA timeout error
> hdl: dma timeout error: status=0xd0 { Busy }
> hdk: DMA disabled
> hdl: DMA disabled
> hdl: status error: status=0x00 { }
> hdl: drive not ready for command
> hdl: status error: status=0x00 { }
> hdl: drive not ready for command
> hdl: status error: status=0x00 { }
> hdl: drive not ready for command
> hdl: status error: status=0x00 { }
> hdl: drive not ready for command
> end_request: I/O error, dev hdl, sector 305100095
> raid5: Disk failure on hdl1, disabling device. Operation continuing on 7
> devices
> end_request: I/O error, dev hdl, sector 305100103
> end_request: I/O error, dev hdl, sector 305100111
> end_request: I/O error, dev hdl, sector 305100119
> .
> .
> .
>
> Jedná se o RAID5 pole z 8 disků. Jeden disk jsem už vyměnil, SeaTools
> na něm našel chyby - ostatní disky byly OK. A teď zase podobná
> hláška a odstavení dalšího disku :-(. Dokonce jsem disky zapojil přes
> řadiče integrované na MSI desce a vyhodil Kouwelly z PCI.
Podle me vada HW, pokud disky drzi, tak kabely, neutahne to zdroj nebo tak
neco.
Jinak z 8 disku se daji dva vadne behem roka cekat celkem spolehlive.
zdravim
dan
Další informace o konferenci Linux