2 eth karty
Karel Miko
miko na dcit.cz
Pátek Květen 22 19:18:46 CEST 1998
Dobry den,
Cituji Ether-HOWTO
Note that the ISA card detection uses a different method than most
cards. Basically, you ask the cards to respond by sending data to an
ID_PORT (port 0x100). This detection method means that a particular
card will always get detected first in a multiple ISA 3c509
configuration. The card with the lowest hardware ethernet address
will always end up being eth0. This shouldn't matter to anyone, except
for those people who want to assign a 6 byte hardware address to a
particular interface. If you have multiple 3c509 cards, it is best to
append ether=0,0,ethN commands without the i/o port specified (i.e.
use i/o=zero) and allow the probe to sort out which card is first,
otherwise it may not detect all your cards.
Z cehoz teda vyplyva, ze by nejspis stacilo karty prohodit eth0<->eth1
(pokud jsou pouze dve).
KAREL
Další informace o konferenci Linux