Collision na eth0

Marek 'Marx' Grac marx na ns.zero.sk
Úterý Duben 13 15:14:32 CEST 1999


	Nazdar
	Chcel by som sa opytat preco mozem mat na eth0 collision.
	Lebo podla mna je to vsetko spravne, aspon v to dufam 
	Vzhladom na to ze mi vsetko chodi ma to az tak netrapi, ale po
istom case, mi spadne Cisco na buffer overflow.
	BTW: eth0 infinite loop in interrupt status 2011, pise aj na
kerneli 2.2.2, aj 2.2.5. Vie mi dakto poradit nieco o erroroch na eth0 ?
a uz vypisi -->

route -->
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
localnet        *               255.255.255.0   U     0      0        0 eth0
loopback        *               255.0.0.0       U     0      0        0 lo
default         195.146.24.193  0.0.0.0         UG    1      0        0 eth0

ifconfig eth0 -->
eth0      Link encap:Ethernet  HWaddr 00:10:4B:02:F5:6B  
          inet addr:195.146.24.222  Bcast:195.146.24.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:5000 errors:1 dropped:0 overruns:0 frame:1
          TX packets:3585 errors:0 dropped:0 overruns:0 carrier:0
          Collisions:91 
          Interrupt:10 Base address:0x300 



  _____________________  	  ________________________
 /                     \ 	 /			  \
I   Marek 'Marx' Grac   I	I   Laska je jako penize,  I
I			I	I      jeden ji ma moc,	   I
I  marx na zero.sk		I	I      a druhy ne dost.    I
I         grac na gjh.sk	I	I			   I
 \______________________/	I	Petr Kalandra 	   I
				 \________________________/



Další informace o konferenci Linux