Abit BP6, HPT366, ATA66

[Zdenek Kabelac]

Martin Frys wrote:
> 
> Zdarec,
> zkompiloval jsem kernel 2.3.42 s podporou pro HPT366
> lec pri bootu to napise:
> 
> HPT366: onboard version of chipset, pin1=1 pin2=2
> HPT366: IDE controler on PCI bus 00 dev 98
> HPT366: not 100% native mode: will probe irqs later
>    ide2: BM-DMA at 0xe000-0xe007, BIOS settings: hde: DMA, hdf:pio
> HPT366: IDE controler on PCI bus 00 dev 99
> HPT366: not 100% native mode: will probe irqs later
>    ide3: BM-DMA at 0xec00-0xec07, BIOS settings: hdg: pio, hdh:pio
> hde: QUANTUM FIREBALLP KX13.6, ATA DISK drive
>   ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14
>   ide2 at 0xd800-0xd807, 0xdc02 on irq 11
> 
> a zmrzne
> neni mi jasne, jak najde zbytek linuxu na hde, protoze kdyz prepojim
> ksandu do ATA33 tak nabootuju a mam linux na /dev/hda6


root=/dev/hde6  - jako parametr pro kernel boot.
(a nebo zkusit pci=reverse - ale s tim muzou byt problemy)

Je taky potreba upravit /etc/fstab aby se nasly disky na spravnem mist.
plati ze hda, hdb, hdc, hdd jsou standardni 2x2 IDE
hde,... jsou dalsi IDE radice - tedy i ten HPT266

-- 
         binary drivers cause sclerosis of the kernel (mark hahn)
  Zdenek Kabelac  http://i.am/kabi/ kabi na i.am {debian.org; fi.muni.cz}