Diald

[Rafael Noas]

Zatim tady je vypis netstat -rn a ifconfig po spousteni diald:


[root na xl266 config]# netstat -rn
Kernel IP routing table
Destination     Gateway         Genmask         Flags   MSS Window  irtt
Iface
127.0.0.4       0.0.0.0         255.255.255.255 UH        0 0          0
tap0
172.16.1.16     0.0.0.0         255.255.255.255 UH        0 0          0
eth0
127.0.0.0       0.0.0.0         255.255.255.0   U         0 0          0
tap0
172.16.0.0      0.0.0.0         255.255.0.0     U         0 0          0
eth0
127.0.0.0       0.0.0.0         255.0.0.0       U         0 0          0
lo
0.0.0.0         0.0.0.0         0.0.0.0         U         0 0          0
tap0


[root na xl266 config]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:00:F8:20:B0:AF  
          inet addr:172.16.1.16  Bcast:172.16.255.255  Mask:255.255.0.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:7765 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1920 errors:0 dropped:0 overruns:0 carrier:0
          collisions:55 txqueuelen:100 
          Interrupt:10 Base address:0x8800 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:8020  Metric:1
          RX packets:148 errors:0 dropped:0 overruns:0 frame:0
          TX packets:148 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 

tap0      Link encap:Ethernet  HWaddr FE:FD:00:00:00:00  
          inet addr:127.0.0.5  Bcast:0.0.0.0  Mask:255.255.255.0
          UP BROADCAST RUNNING NOARP MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:234 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          

Rekl bych ze vsechno vypada tak jak ma byt ale je jasny ze neco tomu
pppd se nelibi.


-----Original Message-----
From: Jaroslav Stribrsky [mailto:Jaroslav.Stribrsky na vscht.cz]
Sent: Friday, October 20, 2000 4:45 PM
To: linux na linux.cz
Subject: Re: Diald


Moc moudry z toho nejsem :-(  Mozna by to chtelo prekompilovat jadro a
zahrnout
tu podporu pro SLIP primo do nej (ted je to modularne ne ?). Me
automaticky po
prekompilaci a nastartovani diald (ted nevim, jestli i bez startu diald)
pribyl
interface sl0 a na nej byla smerovana default routa. Jak vypada vypis
route -n,
pripadne ifconfig (staci ktery interfacy jsou nahozeny) ?