INSTALACE LINUXE

[Milan Kerslager]

On Sat, 14 Apr 2001, [windows-1250] Krišpín wrote:

> Zdravim, uz asi 6x sem instaloval Linux a vzdycky po instalaci mi to
> pri bootovani napise L a tam se to zastavi a nenabootuje... nevite
> nekdo, co s tim??

V /usr/share/doc/lilo-21.4.4/README mam napsano to, co je uvedeno nize.
LILO kazdym pismenkem dava najevo, co se povedlo dokoncit. Doporucuje se
venovat geometrii disku (mozna lba32, viz ten text dole):


LILO start message
- - - - - - - - -

When LILO loads itself, it displays the word "LILO". Each letter is
printed
before or after performing some specific action. If LILO fails at some
point, the letters printed so far can be used to identify the problem.
This
is described in more detail in the technical overview.

Note that some hex digits may be inserted after the first "L" if a
transient disk problem occurs. Unless LILO stops at that point, generating
an endless stream of error codes, such hex digits do not indicate a severe
problem.

(<nothing>)  No part of LILO has been loaded. LILO either isn't installed
    or the partition on which its boot sector is located isn't active.
L <error> ...   The first stage boot loader has been loaded and started,
    but it can't load the second stage boot loader. The two-digit error
    codes indicate the type of problem. (See also section "Disk error
    codes".) This condition usually indicates a media failure or a geometry
    mismatch (e.g. bad disk parameters, see section "Disk geometry").
LI  The first stage boot loader was able to load the second stage boot
    loader, but has failed to execute it. This can either be caused by a
    geometry mismatch or by moving /boot/boot.b without running the map
    installer.


-- 
                        Milan Kerslager
                        E-mail: milan.kerslager na spsselib.hiedu.cz
                        WWW:    http://www.spsselib.hiedu.cz/~kerslage/