NETDEV WATCHDOG: eth0 transmit timed out

[duscer na seznam.cz]

Pri pokusu Pinknout na jiny pocitac se nedeje "nic", v logu se objevuje
hlaseni:

NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=117.
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=27837.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=39.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=21.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=339.
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=339.
eth0: no IPv6 routers present
eth0: no IPv6 routers present
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x2, t=69019.


-----------------------------------------------------------
Na dva, tenkym Ethernetem spojene, pocitace jsem nainstaloval Suse Linux 7.2
CZ (sitove karty ISA 16bit - pod Win detekovany jako NE2000). Chte miti
fungujici sit, jsem na obou shodne nastavil rozhrani eth0, /dev/hosts,
/dev/networks, ifconfig

Z pocitace nazvaneho SERVER (spusten Linux) na CLIENT pinknu pouze, jsou-li
na CLIENT spusteny Win. Po spusteni Linuxu i na CLIENT a pokusu pinknout z
nej na SERVER se nedeje nic jen v logu CLIENT se s objevuje vyse vypsane
hlaseni. Pink ze SERVER na CLIENT je taktez poz odezvy ale bez vyse uvedeneho
hlaseni v logu SERVER.




za ochotu poradit predem dekuji
Dusan Cerny




Vypis ze stanice SERVER
======================

IFCONFIG
**************
eth0      Link encap:Ethernet  HWaddr 08:00:00:00:15:25   inet
addr:192.168.1.2  Bcast:192.168.1.255  Mask:255.255.255.0 UP
BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:1 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b)  TX bytes:180 (180.0 b)
Interrupt:5 Base address:0x320

lo        Link encap:Local Loopback           inet addr:127.0.0.1
Mask:255.0.0.0           UP LOOPBACK RUNNING  MTU:16436  Metric:1
RX packets:36 errors:0 dropped:0 overruns:0 frame:0
TX packets:36 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2484 (2.4 Kb)  TX bytes:2484 (2.4 Kb)


ROUTE
******************
Kernel IP routing table
Dest.  Gateway     Genmask         Flags Metric Ref   Use Iface
sit           *        255.255.255.0         U     0      0         eth0


HOSTS
*******************
127.0.0.1       localhost
192.168.1.1   server.home.net         server
192.168.1.2   client.home.net          client

::1             localhost ipv6-localhost ipv6-loopback

fe00::0        ipv6-localnet
ff00::0         ipv6-mcastprefix
ff02::1         ipv6-allnodes
ff02::2         ipv6-allrouters
ff02::3         ipv6-allhosts


NETWORKS
********************
loopback   127.0.0.0
sit             192.168.1.0

-------------------------------------------------------