attempt to access beyond end of device

[Jirka Kosina]

Zdravim,

> fsck probehne v pohode (vypada to, ze se rozpada FS)? Muzete zkusit
> novejsi jadro (2.4.3-2.14.14 z Raw Hide) nebo Linusovo 2.4.4 (treba i
> 2.4.5-pre1). Pokud pouzijete glibc pro i386, muzete zkusit i jadro 2.2.x.

Zkusim.

> > pri nejakych manipulacich s diskem. Vcera se to dokonce dopracovalo do
> > takoveho stavu, ze kldyz jsem rebootoval, tak kernel panic, s hlaskou
> > ve smyslu, ze EIP ukazuje na 000000, coz je spatne, a ze by init musel
> > zabit sam sebe, a konec.
> Nemate nahodou VIA chipset (viz lspci)? Nepouzivate prilis optimisticke
> paramatry pro disk (hdparm)?

$ lspci
00:00.0 Host bridge: Acer Laboratories Inc. [ALi] M1621 (rev 05)
00:01.0 PCI bridge: Acer Laboratories Inc. [ALi] M5247 (rev 01)
00:07.0 ISA bridge: Acer Laboratories Inc. [ALi] M1533 PCI to ISA Bridge
[Aladdin IV] (rev c3)
00:0e.0 VGA compatible controller: Trident Microsystems TGUI
9660/968x/968x (rev d3)
00:0f.0 IDE interface: Acer Laboratories Inc. [ALi] M5229 IDE (rev c1)

$ hdparm -q /dev/hda
/dev/hda:
 geometry     = 790/255/63, sectors = 12706470, start = 0

$ hdparm -i /dev/hda
 Model=ST36531A, FwRev=3.05, SerialNo=VS422406
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
 RawCHS=13446/15/63, TrkSize=0, SectSize=0, ECCbytes=0
 BuffType=unknown, BuffSize=128kB, MaxMultSect=32, MultSect=32
 CurCHS=13446/15/63, CurSects=-492437311, LBA=yes, LBAsects=12706470
 IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes: pio0 pio1 pio2 pio3 pio4
 DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2

Predem moc diky.

-- 
JiKos.