attempt to access beyond end of device

[Jan Marek]

Dobry den,

On Sat, May 12, 2001 at 06:10:39PM +0200, Jirka Kosina wrote:
> $ hdparm -q /dev/hda
> /dev/hda:
>  geometry     = 790/255/63, sectors = 12706470, start = 0
> 
> $ hdparm -i /dev/hda
>  Model=ST36531A, FwRev=3.05, SerialNo=VS422406
>  Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
>  RawCHS=13446/15/63, TrkSize=0, SectSize=0, ECCbytes=0
>  BuffType=unknown, BuffSize=128kB, MaxMultSect=32, MultSect=32
>  CurCHS=13446/15/63, CurSects=-492437311, LBA=yes, LBAsects=12706470
>  IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
>  PIO modes: pio0 pio1 pio2 pio3 pio4
>  DMA modes: mdma0 mdma1 mdma2 udma0 udma1 *udma2

mozna by spise byl lepsi vypis z prikazu hdparm /dev/hda

Pokud tam nastavujete take 32-bit pristup pomoci hdparm -c1
/dev/hda, tak to muze byt tim... Ja jsem si takto poskodil
filesystem asi tak 5x, nez jsem na to prisel. V manualu k
hdparm-u se pise, ze nektere radice/chipsety potrebuji jako parametr
k -c dat "3", protoze po kazdem zapisu potrebuji jakousi sync
sekvenci... No proste, viz man hdparm. Nakonec jsem radeji
nastavil -c0 a -d1 a jede to slusne...

> 
> Predem moc diky.
> 
> -- 
> JiKos.

Zdravi
Honza Marek
-- 
Ing. Jan Marek
University of South Bohemia
Academic Computer Centre
Phone: +420-38-7772080