Zalohovani DB Informix, resp. linuxu na Quantum DLT 4000

[Pavel Kankovsky]

On Mon, 27 Jan 2003, Karel Tatransky wrote:

> /opt/informix/bin/ontape -s -L 0 <<_EOI_

A dal uz ten skript nepokracoval? Ocekaval bych nejaka data pro ontape
ukoncena radkem "_EOI_".

> megaraid: [3.13:1.43] detected 1 logical drives
> scsi0: AMI MegaRAID 3.13 254 commands 16 targs 1 chans
> scsi: 1 host.
> scsi0: scanning channel A for devices.
> Vendor: DELL Model: 1x6 U2W SCSI BP Rev: 5.33
> Type: Processor      ANSI SCSI revision: 02
> scsi0: scanning channel B for devices.
> Vendor: MegaRaid Model: LDO RAID 5 34556R Rev: 3.13
> Type: Direct-Access   ANCI SCSI Revision: 02
> Detected scsi disk sda at scsi0, channel 1, id 0, lun 0
> scsi: detected 1 SCSI disk total.
> ....
> 
> O zarizeni st0 ani slovo. K tomu manual doporucuje: "If you don't see
> this, you'll have to rebuild the kernel with st support included."

Provedte "grep st /proc/devices". Pokud tam nic nebude, pak jeste zkuste
"modprobe st" a znovu ten grep. Pokud porad nic, pak jeste "depmod -a"
a jeste jednou modprobe. Pokud ani tohle nepomzue, pak asi opravdu
provozujete jadro bez pasky.

Ale nevim, po pravde receno si myslim, ze paska by ve vypisu z jadra pri
bootu resp. v /proc/scsi/scsi mela byt videt bez ohledu na to, zda je
povoleno zarizeni st nebo ne.

--Pavel Kankovsky aka Peak  [ Boycott Microsoft--http://www.vcnet.com/bms ]
"Resistance is futile. Open your source code and prepare for assimilation."