802.1q: Linux vs. Cisco Catalyst 6500

[Petr Simek]

On Sat, 29 Mar 2003, Borek Lupomesky wrote:

> Petr Simek wrote:
>
> > set vlan 156 name Lib type ethernet mtu 1500 said 100156 state active
> > #module 4 : 9-port Gigabit Ethernet
> > set vlan 156  4/5
> > clear trunk 4/4  1-155,157-1005
> > set trunk 4/4  on dot1q 156
>
>     Nojo, tak to je to same, co tam mam ja. Kazdopadne diky za info, ze
> vam to funguje. Snad nekdy najdu cas se na to podivat.

Neni od veci napred 802.1q vypnout a zkusit jen native mod - to musi
chodit, kdyz ne, muze byt problem v nastaveni portu - pri spojeni s
nekterymi zarizenimi jsme davali :

#module 4 : 9-port Gigabit Ethernet
set port negotiation 4/2,4/5,4/7 disable

nebo na twistu :

#module 1 : 2-port 10/100BaseTX Supervisor
set port speed      1/2  100
set port duplex     1/2  full

Je mozne ze to muze viset na tom ze se ty zarizeni nejak blbe domluvi.

>     Borek

*------------------------------------------------------------------------*
|                          Petr Simek   APS JU                           |
|                             psimek na jcu.cz                              |
*------------------------------------------------------------------------*