99 99 99 99... namisto bootu u Salckware
Karel Dudasek
karel.dudasek na vghur.army.cz
Středa Prosinec 14 18:25:20 CET 2005
On Wed, 14 Dec 2005, Balog Martin - TENEL wrote:
> Pouze jeden HDD (/dev/hda1 ../; /dev/hda2 ../tmp a swap). V biosu nic
> prehozeneho neni. Z diskety nabootuji, zkousel sem zapsat i LiLo, lec
> marne - ono bylo confnute dobre. HW test bezel 18 hodin a projel snad
> vse co slo, ovsem naprosto bez chyby.
Dle man lilo zkus lilo -v3.
Tohle by melo znamenat, ze bud neni citelny sekundarni zavadec nebo nesedi
geometrie disku s BIOSem.
Karel Dudasek
Cast vypisu man lilo:
Errors 99 and 9A usually mean the map file (-m
or map=) is not readable, likely because LILO was not re-
run after some system change, or there is a geometry mis-
match between what LILO used (lilo -v3 to display) and
what is actually being used by the BIOS (one of the lilo
diagnostic disks, available in the source distribution,
may be needed to diagnose this problem).
When the second stage loader has received control from the
first stage, it prints the letter "L", and when it has
initialized itself, including verifying the "Descriptor
Table" - the list of kernels/others to boot - it will
print the letter "O", to form the full word "LILO", in
uppercase.
All second stage loader error messages are English text,
and try to pinpoint, more or less successfully, the point
of failure.
INCOMPATIBILITIES
lilo is known to have problems with the reiserfs intro-
duced with the 2.2.x kernels, unless the file system is
mounted with the 'notail' option. This incompatibilty has
been resolved with reiserfs 3.6.18 and lilo 21.6. reiser4
introduced with the 2.5.x kernels requires lilo 22.5.2 or
later.
Další informace o konferenci Linux