Fedora Core 3 a SANblade QLA 200

[Petr Horacek]

Dobry den preji

QLA 200 existuje, viz.
http://www.qlogic.com/support/product_resources.asp?id=760

/proc/scsi/qla* - neexistuje

Vypis /proc/scsi/scsi:

----
Attached devices:
Host: scsi0 Channel: 00 Id: 06 Lun: 00
  Vendor: PE/PV    Model: 1x2 SCSI BP      Rev: 1.0 
  Type:   Processor                        ANSI SCSI revision: 02
Host: scsi0 Channel: 01 Id: 00 Lun: 00
  Vendor: MegaRAID Model: LD 0 RAID1   17G Rev: 513O
  Type:   Direct-Access                    ANSI SCSI revision: 02
----

Pozna jenom integrovany Perc 4e/Si SCSi radic.

Konfigurace grubu:

----
title Fedora Core (2.6.9-1.681_FC3)
root (hd0,0)
kernel /boot/vmlinuz-2.6.9-1.681_FC3 ro root=LABEL=/ max_scsi_luns=128
initrd /boot/initrd-2.6.9-1.681_FC3.img
----

Relevantni cast dmesg: (PCI cast proto, ze jde o PCI kartu na IRQ 3)

----
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 3
ACPI: PCI interrupt 0000:03:0b.0[A] -> GSI 3 (level, low) -> IRQ 3

...

SCSI subsystem initialized
QLogic Fibre Channel HBA Driver (22886000)
megaraid cmm: 2.20.2.0 (Release Date: Thu Aug 19 09:58:33 EDT 2004)
megaraid: 2.20.4.0 (Release Date: Mon Sep 27 22:15:07 EDT 2004)
megaraid: probe new device 0x1028:0x0013:0x1028:0x016c: bus 2:slot 14:func 0
ACPI: PCI interrupt 0000:02:0e.0[A] -> GSI 7 (level, low) -> IRQ 7
megaraid: fw version:[513O] bios version:[H418]
scsi0 : LSI Logic MegaRAID driver
scsi[0]: scanning scsi channel 0 [Phy 0] for non-raid devices
  Vendor: PE/PV     Model: 1x2 SCSI BP       Rev: 1.0 
  Type:   Processor                          ANSI SCSI revision: 02
scsi[0]: scanning scsi channel 1 [virtual] for logical drives
  Vendor: MegaRAID  Model: LD 0 RAID1   17G  Rev: 513O
  Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 35389440 512-byte hdwr sectors (18119 MB)
sda: asking for cache data failed
sda: assuming drive cache: write through
 sda: sda1 sda2 < sda5 sda6 sda7 sda8 >
Attached scsi disk sda at scsi0, channel 1, id 0, lun 0
----

Se SCSI delam prvne, tak jsem z toho trosku mimo.

Karta je funkcni - kdyz ji chytnu do jejiho biosu, tak se s tim polem spoji a ovladaci sw toho pole ji pozna a o spojeni rekne, ze je aktivni.

Diky za pomoc

Petr