Pripjeni harddisku pres USB2IDE controller

[Zdenek Zikan]

>>Takze sd_mod chybi. Bohuzel po jeho pridani se nic nezmenilo.
>>
>>po odpojeni a vypnuti controlleru pribylo v dmesg:
>>usb 3-2: USB disconnect, address 2
>>
>>po opetovnem zapnuti a pripojeni s pridanym sd_mod pribylo v dmesg:
>>usb 3-2: new full speed USB device using address 3
>>scsi1 : SCSI emulation for USB Mass Storage devices
> 
> Vypni ten disk, odeber usb-storage a znovu ho zapni.
> A pak posli dmesg, pripadne koukej do /var/log/messages co se deje.

Rebootuju.

# modprobe sd_mod
# dmesg -c
SCSI subsystem initialized

Pripojim radic s diskem.

# dmesg
usb 3-2: new full speed USB device using address 2
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb 3-2: reset full speed USB device using address 2
scsi: Device offlined - not ready after error recovery: host 0 channel 0 
id 0 lun 0
USB Mass Storage device found at 2
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
inserting floppy driver for 2.6.9-1.6_FC2
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306

(ve /var/log/messages prakticky to same)

Takze zadna zmena

Zdenek Zikan