Pripjeni harddisku pres USB2IDE controller

[Simon]

On Mon, 31 Jan 2005 14:08:10 GMT
Zdenek Zikan <xzikan na fi.muni.cz> wrote:

> >>Takze sd_mod chybi. Bohuzel po jeho pridani se nic nezmenilo.
> >>
> >>po odpojeni a vypnuti controlleru pribylo v dmesg:
> >>usb 3-2: USB disconnect, address 2
> >>
> >>po opetovnem zapnuti a pripojeni s pridanym sd_mod pribylo v dmesg:
> >>usb 3-2: new full speed USB device using address 3
> >>scsi1 : SCSI emulation for USB Mass Storage devices
> > 
> > Vypni ten disk, odeber usb-storage a znovu ho zapni.
> > A pak posli dmesg, pripadne koukej do /var/log/messages co se deje.
> 
> Rebootuju.
> 
> # modprobe sd_mod
> # dmesg -c
> SCSI subsystem initialized
> 
> Pripojim radic s diskem.
> 
> # dmesg
> usb 3-2: new full speed USB device using address 2
> Initializing USB Mass Storage driver...
> scsi0 : SCSI emulation for USB Mass Storage devices
> usb 3-2: reset full speed USB device using address 2
> scsi: Device offlined - not ready after error recovery: host 0 channel 0 
> id 0 lun 0

-( a to je prave ta chyba .... ten disk je mimo ...
 nema maalo ampeeru ? 

chodil na tomhle zeleze nekdy ? treba i s
 malym-mekkym operacnim systemem s podivnyym cislovanim ? 

mel jsem podobny problem s usb diskem v kastliiku ... nekde-jo nekde-ne 
a vyresilo externi napajeni ... 


> USB Mass Storage device found at 2
> usbcore: registered new driver usb-storage
> USB Mass Storage support registered.
> inserting floppy driver for 2.6.9-1.6_FC2
> Floppy drive(s): fd0 is 1.44M
> FDC 0 is a National Semiconductor PC87306
> 
> (ve /var/log/messages prakticky to same)
>

nevim .. nemam jinej napad ..
hezkej den preju -(