D-Link DWL-510 (rtl 8180)

[Milan Muller]

Dal Horinek napsal(a):
> Dobry den,
>
> zkousim rozchodit tuto WiFi sitovku pod linuxem, nasel jsem zpusob 
> pres ndiswrapper, ale pote i Open Source driver
> ( http://rtl8180-sa2400.sourceforge.net/ )
> Nejprve jsem stahl stable verzi, upravil, aby bylo mozne ji 
> zkompilovat (nic zasadniho, co by melo vliv na problem) a zkompiloval, 
> ovsem sitovka byla videt po loadnuti modulu :
>
> wlan0     Link encap:Ethernet  HWaddr 00:40:05:3F:46:8E          
> BROADCAST MULTICAST  MTU:1500  Metric:1
>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>          Interrupt:5 Memory:d0c46f00-d0c47000
>
> ovsem
>
> iwconfig
> wlan0     no wireless extensions.
>
> pote jsem zkusil verzi z CVS, take nutne upravit, ale porad to stejne. 
> Neustale no wireless extension.
>
> dmesg ukaze:
> Linux kernel driver for RTL8180 / RTL8185 based WLAN cards
> Copyright (c) 2004-2005, Andrea Merello
> rtl8180: Initializing module
> rtl8180: Wireless extensions version 20
> rtl8180: Initializing proc filesystem
> rtl8180: Configuring chip resources
> ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKB] -> GSI 5 (level, 
> low) -> IRQ 5
> rtl8180: Memory mapped space @ 0xdfffff00
> rtl8180: Hardware frame sequence numbers disabled
> rtl8180: MAC controller is a RTL8180 (v. F)
> rtl8180: This is a PCI NIC
> rtl8180: Reported EEPROM chip is a 93c56 (2Kbit)
> rtl8180: Card MAC address is 00:40:05:3f:46:8e
> rtl8180: EEPROM version 102
> rtl8180: RfParam: 5
> rtl8180: Card reports RF frontend by Philips.
> rtl8180: OK! Philips SA2400 radio chipset is supported.
> rtl8180: Analog PHY found
> rtl8180: Energy threshold: b
> rtl8180: PAPE from CONFIG2: 1
> rtl8180: Antenna A is default antenna
> rtl8180: Antenna diversity is disabled
> rtl8180: Carrier sense 1
> rtl8180: 40-bit WEP is NOT supported in hardware
> rtl8180: 104-bit WEP is NOT supported in hardware
> rtl8180: IRQ 5
> rtl8180: Driver probe completed
>
> iwconfig --version
> iwconfig  Wireless-Tools version 28
>          Compatible with Wireless Extension v11 to v20.
>
> Cannot read /proc/net/wireless
>
>
> jadro je 2.6.17.3 a volby, ktere by to mely ovlivnovat, by mely byt v 
> poradku :
> CONFIG_WIRELESS_EXT=y
> CONFIG_NET_WIRELESS=y
> CONFIG_NET_RADIO=y
> CONFIG_IEEE80211=y
> CONFIG_IEEE80211_DEBUG=y
> CONFIG_IEEE80211_CRYPT_WEP=m
> CONFIG_IEEE80211_CRYPT_CCMP=m
>
> ovsem moduly ieee* jsou smazany a nahrazeny moduly ieee*_r8180, ktery 
> s sebou ma r8180 driver
>
> Jeste dodam, ze distribuce je debian stable, ale wireless-tools jsou z 
> testingu, jelikoz ty ve stable podporuji w. ext. v11 - v17, kdezto 
> karta podporuje v20, coz uz ty z testingu zvladaji.
>
> Tedy, kde muze byt chyba, ze iwconfig zobrazi, ze ta wifi karta 
> nepodporuje wireless extensions? Pokud by nekdo vedel, budu rad.
>
>     Predem dekuji za jakoukoli radu.
>
>                              D. Horinek.
>
Rozcházel jsem ji půl roku, a nakonec prodal a koupil jinou. D-Link v 
Linuxu prostě nejede... :-(