D-Link DWL-510 (rtl 8180)

[Dal Horinek]

Milan Muller wrote:
> Dal Horinek napsal(a):
>> Dobry den,
>>
>> zkousim rozchodit tuto WiFi sitovku pod linuxem, nasel jsem zpusob 
>> pres ndiswrapper, ale pote i Open Source driver
>> ( http://rtl8180-sa2400.sourceforge.net/ )
>> Nejprve jsem stahl stable verzi, upravil, aby bylo mozne ji 
>> zkompilovat (nic zasadniho, co by melo vliv na problem) a 
>> zkompiloval, ovsem sitovka byla videt po loadnuti modulu :
>>
>> wlan0     Link encap:Ethernet  HWaddr 00:40:05:3F:46:8E          
>> BROADCAST MULTICAST  MTU:1500  Metric:1
>>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>>          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>>          collisions:0 txqueuelen:1000
>>          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>>          Interrupt:5 Memory:d0c46f00-d0c47000
>>
>> ovsem
>>
>> iwconfig
>> wlan0     no wireless extensions.
>>
>> pote jsem zkusil verzi z CVS, take nutne upravit, ale porad to 
>> stejne. Neustale no wireless extension.
>>
>> dmesg ukaze:
>> Linux kernel driver for RTL8180 / RTL8185 based WLAN cards
>> Copyright (c) 2004-2005, Andrea Merello
>> rtl8180: Initializing module
>> rtl8180: Wireless extensions version 20
>> rtl8180: Initializing proc filesystem
>> rtl8180: Configuring chip resources
>> ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKB] -> GSI 5 (level, 
>> low) -> IRQ 5
>> rtl8180: Memory mapped space @ 0xdfffff00
>> rtl8180: Hardware frame sequence numbers disabled
>> rtl8180: MAC controller is a RTL8180 (v. F)
>> rtl8180: This is a PCI NIC
>> rtl8180: Reported EEPROM chip is a 93c56 (2Kbit)
>> rtl8180: Card MAC address is 00:40:05:3f:46:8e
>> rtl8180: EEPROM version 102
>> rtl8180: RfParam: 5
>> rtl8180: Card reports RF frontend by Philips.
>> rtl8180: OK! Philips SA2400 radio chipset is supported.
>> rtl8180: Analog PHY found
>> rtl8180: Energy threshold: b
>> rtl8180: PAPE from CONFIG2: 1
>> rtl8180: Antenna A is default antenna
>> rtl8180: Antenna diversity is disabled
>> rtl8180: Carrier sense 1
>> rtl8180: 40-bit WEP is NOT supported in hardware
>> rtl8180: 104-bit WEP is NOT supported in hardware
>> rtl8180: IRQ 5
>> rtl8180: Driver probe completed
>>
>> iwconfig --version
>> iwconfig  Wireless-Tools version 28
>>          Compatible with Wireless Extension v11 to v20.
>>
>> Cannot read /proc/net/wireless
>>
>>
>> jadro je 2.6.17.3 a volby, ktere by to mely ovlivnovat, by mely byt v 
>> poradku :
>> CONFIG_WIRELESS_EXT=y
>> CONFIG_NET_WIRELESS=y
>> CONFIG_NET_RADIO=y
>> CONFIG_IEEE80211=y
>> CONFIG_IEEE80211_DEBUG=y
>> CONFIG_IEEE80211_CRYPT_WEP=m
>> CONFIG_IEEE80211_CRYPT_CCMP=m
>>
>> ovsem moduly ieee* jsou smazany a nahrazeny moduly ieee*_r8180, ktery 
>> s sebou ma r8180 driver
>>
>> Jeste dodam, ze distribuce je debian stable, ale wireless-tools jsou 
>> z testingu, jelikoz ty ve stable podporuji w. ext. v11 - v17, kdezto 
>> karta podporuje v20, coz uz ty z testingu zvladaji.
>>
>> Tedy, kde muze byt chyba, ze iwconfig zobrazi, ze ta wifi karta 
>> nepodporuje wireless extensions? Pokud by nekdo vedel, budu rad.
>>
>>     Predem dekuji za jakoukoli radu.
>>
>>                              D. Horinek.
>>
> Rozcházel jsem ji půl roku, a nakonec prodal a koupil jinou. D-Link v 
> Linuxu prostě nejede... :-(
Skoda, tak koupim radeji AP .. s tim nebude tolik problemu snad :)

   Diky za info.

-- 
== www.horinek.net ==
Dalibor Horinek
ICQ: 178217372