nastaveni ppp pro ADSL

[Ing. Karel Babka]

Motyčka Jiří Mgr. napsal(a):
> Dobry den vespolek.
> 

Dobrý večer
> Mam USB ADSL modem Well Asu 8000. S driverem jsem nemel problem. Na cxacru
> + firmware z jadra 2.6.18 se chytne vpohode (prepokladam to podle toho, ze
> dle logu detekuje ADSL linku s danymi rychlostmi upload a download).
> 
> Problem mam v tom, jak nastavit ppp protokol tak, aby se v ceskych
> podminkach pripojil k ADSL siti O2.
> 
> Po delsim boji jsem se dozvedel, ze musim konfigurovat pppoe misto pppoa,
> ale z hodnot a parametru, ktere tam musim zadat jsem nebyl moc chytry.
> 
> Nekde jsem se docetl o hodnotach VPI a VCI, ktere jsou pro Cechy pry 8 a
> 48, ale nevim kam s nimi.


Také jsem se s tím potýkal, vytahuji z manuálu ke svému modemu:

  The devices WAN-side interfaces are used to communication via the DSL port. A WAN interface comprises two layers: a lower-level 
ATM VC interface and a higher-level protocol interface:

     *

       The ATM VC interface enables the device to communicate using the Asynchronous Transfer Mode protocol. The ATM protocol 
provides a common format for transmitting data over a variety of hardware systems that make up the backbone of the Internet. The 
virtual circuit (VC) properties of the ATM VC interface identify a unique path that your ADSL/Ethernet router uses to communicate 
via the ATM-based network with the telephone company central office equipment.

Vpi, Vci, and  Mux Type: These settings identify a unique ATM data path for communication between your ADSL/Ethernet router and 
your ISP.

     *

       The higher-level protocol interface(s) operate "on top" of the ATM VC interface. The higher-level interface handles the 
protocols needed to log onto and exchange data with the ISP's access server. ISPs can use several different protocols, including 
the Point-to-Point Protocol (PPP), Ethernet-over-ATM (EoA) protocol, or the Internet Protocol-over-ATM (IPoA). Be sure to create 
the specific type of WAN interface your ISP requires.

After you have defined the ATM VC properties as described in this topic, you can configure one of the higher level WAN interfaces 
to enable communication with your ISP.

--
Karel Babka