Driver a nastavenie PCMCIA Omnikey Cardman 4040

[Jozef Slovak]

Zdravim Vas.

Na notebooku mam nainstalovamy Open SUSE 12.1.
Mam problem s nainstalovanim PCMCIA karty Cardman 4040.
Stiahol som zo strany vyrobcu driver pre linux .(ifdoc_cm4040_lnx-2.0.0)
Po rozbaleni a spusteni instalacie ohlasi :

Installing OMNIKEY CardMan 4040 smartcard reader driver ...

PCMCIA support is not installed.
Go visit pcmcia-cs.sourceforge.net
and install the latest version of PCMCIA support

Na www stranke som nasiel ,len ze ak chcem tento sw pre novsiu verziu
jadra mam ist na stranku ..... a nic tam nieje.
Zhanal som po internete dalsie informacie . Nasiel som pcmcia-cs 3.2.8.
Ale ked pustim Configure ,odsuhlasim default nastavenie ,
tak mi ohlasi:

Kernel configuration options:
    Kernel-tree PCMCIA support is disabled.
    Symmetric multiprocessing support is disabled.
    Preemptive kernel support is disabled.
    Realtime Hardware Abstraction Layer is disabled.
    High memory support is disabled.
    PCI BIOS support is disabled.
    Power management (APM) support is disabled.
    SCSI support is disabled.
    IEEE 1394 (FireWire) support is disabled.
    Networking support is disabled.
     Radio network interface support is enabled.
     Token Ring device support is disabled.
     Fast switching is disabled.
     Frame Diverter is disabled.
    Module version checking is disabled.
    Kernel debugging support is disabled.
    /proc filesystem support is disabled.
    PAE support is disabled.

Cardbus support requires kernel PCI bus support!
    To fix, re-run 'make config' and disable Cardbus support. 

No a tu uz neviem . 

LSMOD ohlasi:

cm4040_cs              19366  1 
pcmcia                 55754  1 cm4040_cs
parport_pc             36673  0 
ppdev                  17430  0 
snd_intel8x0m          18539  0 
ipw2200               189676  0 
snd_intel8x0           33318  2 
libipw                 50797  1 ipw2200
yenta_socket           40666  0 
snd_ac97_codec        114276  2 snd_intel8x0m,snd_intel8x0
cfg80211              183430  2 ipw2200,libipw
pcmcia_rsrc            18495  1 yenta_socket

Podla mna uz to tam vsetko mam . Len aky soft pouzit na konfiguraciu karty
, pinu, prihlasenia pomocou karty a tak ?


Poradite mi ???


Jozef