zdraví disku
jaroslav noví
oldcpu na centrum.cz
Neděle Listopad 26 13:36:50 CET 2017
Ahoj všem,
začal jsem mít drobné potíže s jedním z disků. NAhodile se odpojoval. při pokusu o přimountování hlásil poškozený superblok a podobné veselé zprávy.
Když jsem se kouknul pomocí:
smartctl -x /dev/sde
co mu sau tak chybí dostel jsem výpis:
smartctl -a /dev/sde
smartctl 6.4 2015-06-04 r4109 [x86_64-linux-4.9.49-gentoo-r1] (local build)
Copyright (C) 2002-15, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.11
Device Model: ST31500341AS
Serial Number: 9VG0M1L7
LU WWN Device Id: 5 000c50 01081749b
Firmware Version: LC1A
User Capacity: 1 500 301 910 016 bytes [1,50 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7200 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Sun Nov 26 13:23:57 2017 CET
==> WARNING: There are known problems with these drives,
see the following Seagate web pages:
http://knowledge.seagate.com/articles/en_US/FAQ/207931en
http://knowledge.seagate.com/articles/en_US/FAQ/207951en
http://knowledge.seagate.com/articles/en_US/FAQ/207957en
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 249) Self-test routine in progress...
90% of test remaining.
Total time to complete Offline
data collection: ( 617) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 299) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail Always - 158521203
3 Spin_Up_Time 0x0003 090 089 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 098 098 020 Old_age Always - 2152
5 Reallocated_Sector_Ct 0x0033 099 099 036 Pre-fail Always - 58
7 Seek_Error_Rate 0x000f 078 060 030 Pre-fail Always - 68911493
9 Power_On_Hours 0x0032 082 082 000 Old_age Always - 16064
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 3
12 Power_Cycle_Count 0x0032 098 037 020 Old_age Always - 2154
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 072 072 000 Old_age Always - 28
188 Command_Timeout 0x0032 100 098 000 Old_age Always - 38655295497
189 High_Fly_Writes 0x003a 068 068 000 Old_age Always - 32
190 Airflow_Temperature_Cel 0x0022 061 048 045 Old_age Always - 39 (Min/Max 25/41)
194 Temperature_Celsius 0x0022 039 052 000 Old_age Always - 39 (0 18 0 0 0)
195 Hardware_ECC_Recovered 0x001a 049 015 000 Old_age Always - 158521203
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 28 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 28 occurred at disk power-on lifetime: 16059 hours (669 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 ff ff ff ef 00 00:52:36.004 READ DMA EXT
25 00 01 ff ff ff ef 00 00:52:36.002 READ DMA EXT
25 00 01 ff ff ff ef 00 00:52:36.002 READ DMA EXT
25 00 01 ff ff ff ef 00 00:52:36.002 READ DMA EXT
25 00 01 ff ff ff ef 00 00:52:36.002 READ DMA EXT
Error 27 occurred at disk power-on lifetime: 16059 hours (669 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 ff ff ff ef 00 00:37:26.984 READ DMA EXT
25 00 01 ff ff ff ef 00 00:37:26.982 READ DMA EXT
25 00 01 ff ff ff ef 00 00:37:26.982 READ DMA EXT
25 00 01 ff ff ff ef 00 00:37:26.982 READ DMA EXT
25 00 01 ff ff ff ef 00 00:37:26.981 READ DMA EXT
Error 26 occurred at disk power-on lifetime: 16059 hours (669 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 ff ff ff ef 00 00:19:42.216 READ DMA EXT
25 00 01 ff ff ff ef 00 00:19:42.215 READ DMA EXT
25 00 01 ff ff ff ef 00 00:19:42.214 READ DMA EXT
25 00 01 ff ff ff ef 00 00:19:42.214 READ DMA EXT
25 00 01 ff ff ff ef 00 00:19:42.214 READ DMA EXT
Error 25 occurred at disk power-on lifetime: 16059 hours (669 days + 3 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 ff ff ff ef 00 00:17:55.118 READ DMA EXT
25 00 01 ff ff ff ef 00 00:17:55.108 READ DMA EXT
25 00 01 ff ff ff ef 00 00:17:55.104 READ DMA EXT
25 00 01 ff ff ff ef 00 00:17:55.096 READ DMA EXT
25 00 01 ff ff ff ef 00 00:17:55.089 READ DMA EXT
Error 24 occurred at disk power-on lifetime: 16058 hours (669 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 ff ff ff ef 00 00:10:27.245 READ DMA EXT
25 00 01 ff ff ff ef 00 00:10:27.243 READ DMA EXT
25 00 01 ff ff ff ef 00 00:10:27.243 READ DMA EXT
25 00 01 ff ff ff ef 00 00:10:27.243 READ DMA EXT
25 00 01 ff ff ff ef 00 00:10:27.243 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Self-test routine in progress 90% 16064 -
# 2 Extended offline Completed: read failure 90% 16059 1465644898
# 3 Extended offline Completed: read failure 90% 16059 1465644884
# 4 Extended offline Completed: read failure 90% 16059 1465644873
# 5 Extended offline Completed: read failure 90% 16059 1465645453
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
Tipnul bych si, že je skoro s podivem, že ještě žije.
Jak by zhodnotili znalci stav tohodle kousku?
p.s.
data mám zkopírována na nový disk.
OC
Další informace o konferenci Linux