Zkusenosti s dynamickym diskem W2k a Linuxem

[MUDr. Vítězslav Podivínský]

Tak se zda, ze tady to je napsano:

3.4 Lilo
When you come to the Lilo-Section, specify your Linux-root-partition as your
boot device because the Master Boot Record (MBR) of your harddisk is owned
by Windows NT. This means that the root-entry and the boot-entry in your
/etc/lilo.conf have the same value. If you have a IDE-harddisk and your
Linux-partition is is the second partition, your boot-entry in
/etc/lilo.conf looks like:

boot=/dev/hda2

If you have two disks and your Linux resides on the first partition of your
second disk, your boot-entry in /etc/lilo.conf looks like:

boot=/dev/hdb1

Run lilo with a kernel that matches your system. Check the kernel by booting
from diskette first if you are not sure.

If you cannot boot Windows NT now, you have a problem. I hope you have
created a repair-disk recently.

Pokud toto plati i pro W2k( a ze plati:-))), pak jsem blb.
Omlouvam se pak vsem za vicemene spam.
Daktari


Old:Pratele:
Old:Mam konfiguraci:
Old:Na ata 66 radicich mam jako primary master Teac CD-R512EP,
Old:primary slave pak DVDcko).
Old:Promise ultra ata 100 primary master 45GB( W2k, dynamicky
Old:disk, NTFS),
Old:secondary master 45GM, rozdelen na tri partiones: na hg4 je
Old:SuSE Linux 7,2 CZ, na hg2 pak Red Hat 7,1 CZ a treti je
Old:swap prostor.
Old:Cetl jsem leccos, ale o dynamickem disku jsem se toho moc
Old:nedozvedel. Docela mam obavu pustit LILO na tento disk,
Old:zatim bootuji z disket (tedy Linuxy:-)).
Old:Dekuji za tip, kde bych prisel k rozumnemu reseni. Chtel
Old:bych "prdnout" LILO do MBR!
Old:Daktari