ISDN & linux ..

[Dan Ohnesorg]

On Thu, 29 Mar 2001, Jan ' Kozo ' Vajda wrote:

> MSN cislo som nastavoval cez AT&Ecislo a hlasilo OK ..( ale kto to hlasil
> nie som isty :-{))

Tak jsem nevydrzel a kouknul jsem se k 3comum co oni na to. Predpokladam,
ze  to mate na seriovem portu, pac USB verze neni podporovovana. O
nastaveni parametru pisi toto:

Issue:  How do I program the SPIDs and other ISDN line information for my
ISDN TA without using the ControlCenter software or the PID Wizard?

Solution:  Open a terminal program, such as Hyperterminal.

To set your switch protocol, type AT*W=n and press Enter. Type the number
that corresponds to your switch type in the place of n, using the list
below as reference.

n=1 DMS-100
n=2 National ISDN-1 (default)
n=3 National ISDN-2
n=4 5ESS Custom Multipoint
n=5 5ESS Custom Point-to-Point
n=6 Leased Line 64 kbps (1 B-channel)
n=7 Leased Line 128 kbps (2 B-channels)

To enter your area code information, type AT*P0=xxx and press Enter. In
the place of xxx, type your area code.

To enter a telephone number for your ISDN TA, type AT*P1=xxx and press
Enter. In the place of xxx, type one of the telephone numbers for your
ISDN line. To enter a second telephone number, type AT*P2=xxx and press
Enter. Type the second telephone number in the place of xxx.

To enter the SPID for your first telephone number, type AT*S1=xxx and
press Enter. Type the SPID in the place of xxx. To enter the SPID for your
second telephone number, type AT*S2=xxx and press Enter. Again, type the
SPID in the place of xxx.

Once your numbers have been set, type ATZ! to resynchronize your ISDN TA
to the telephone company's switch equipment. The alert light will turn off
when the ISDN TA is properly synchronized to the telephone company switch.
This may take one minute to complete.

These settings do not have to be saved using the &W command.


Cili &E tam neni.

Jeste jsem se kouknul do manualu a na strane 65 pisou:

AT*PPP=1, coz bude asi spravna volba

na strane 88 pisou, ze AT$ vypise help k AT prikazum

ATX znamena jak podrobne jsou hlasky, ktere to hlasi, takze ATX3 nema s
dial tone nic spolecneho.

Hlasku No dialtone neni mozne dostat, protoze zadnou takovou to podle
manualu nevraci.

Kazdopadne kdyby to bylo mozne rad bych se s tim zarizenim seznamil.


zdravim
dan

-- 
                    ________________________________________
DDDDDD
DD   DD                Dan Ohnesorg, supervisor on POWER
DD  OOOO               Dan na feld.cvut.cz
DD OODDOO              Dep. of Power Engineering
DDDDDD OO              CTU FEL Prague, Bohemia
   OO  OO              work: +420 2 24352785;+420 2 24972109
    OOOO               home: +420 311 679679;+420 311 679311
                    ________________________________________

Nekdy je rozumne o krok ustoupit, aby se prodlouzil rozbeh.