Partition check v jadru + vytuhly HDD

[Petr Ruzicka]

Dobry den
Jenou (urcite ne naposledy) jsem startoval sve PC, pricemz mi pri startu
napsal :

Linux version 2.4.19-pre7 (root) (gcc version 2.96 20000731 (Red Hat
Linux 7.3 2.96-110)) #3 Út dub 23 18:25:39 CEST 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000fff0000 (usable)
 BIOS-e820: 000000000fff0000 - 000000000fff3000 (ACPI NVS)
 BIOS-e820: 000000000fff3000 - 0000000010000000 (ACPI data)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
255MB LOWMEM available.
On node 0 totalpages: 65520
zone(0): 4096 pages.
zone(1): 61424 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=linux ro root=2201
BOOT_FILE=/boot/vmlinuz hdc=ide-scsi hdb=ide-scsi panic=60
video=vesa:mtrr
ide_setup: hdc=ide-scsi
ide_setup: hdb=ide-scsi
Initializing CPU#0
Detected 1200.077 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 2392.06 BogoMIPS
Memory: 256360k/262080k available (1571k kernel code, 5332k reserved,
434k data, 252k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383f9ff c1cbf9ff 00000000, vendor = 2
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
CPU: After vendor init, caps: 0383f9ff c1cbf9ff 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0383f9ff c1cbf9ff 00000000 00000000
CPU:             Common caps: 0383f9ff c1cbf9ff 00000000 00000000
CPU: AMD Duron(tm) processor stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfb4e0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Disabling VIA memory write queue: [55] 89->09
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router VIA [1106/0686] at 00:07.0
Applying VIA southbridge workaround.
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.4.0 initialized
Journalled Block Device driver loaded
Installing knfsd (copyright (C) 1996 okir na monad.swb.de).
NTFS driver v1.1.22 [Flags: R/W]
ACPI: APM is already active, exiting
i2c-core.o: i2c core module
i2c-dev.o: i2c /dev entries driver module
i2c-core.o: driver i2c-dev dummy driver registered.
i2c-proc.o version 2.6.1 (20010825)
vesafb: framebuffer at 0xe0000000, mapped to 0xd080d000, size 32768k
vesafb: mode is 1280x1024x8, linelength=1280, pages=2
vesafb: protected mode interface info at c000:0f3e
vesafb: scrolling: redraw
Console: switching to colour frame buffer device 160x64
fb0: VESA VGA frame buffer device
rivafb: cannot reserve FB region
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI enabled
ttyS01 at 0x03f8 (irq = 4) is a 16550A
ttyS02 at 0x02f8 (irq = 3) is a 16550A
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
    ide0: BM-DMA at 0xc000-0xc007, BIOS settings: hda:pio, hdb:DMA
    ide1: BM-DMA at 0xc008-0xc00f, BIOS settings: hdc:DMA, hdd:pio
HPT370: IDE controller on PCI bus 00 dev 98
PCI: Found IRQ 11 for device 00:13.0
HPT370: chipset revision 3
HPT370: not 100% native mode: will probe irqs later
HPT370: using 33MHz PCI clock
    ide2: BM-DMA at 0xe400-0xe407, BIOS settings: hde:DMA, hdf:pio
    ide3: BM-DMA at 0xe408-0xe40f, BIOS settings: hdg:DMA, hdh:pio
hdb: TOSHIBA DVD-ROM SD-M1502, ATAPI CD/DVD-ROM drive
hdc: CD-W516EB, ATAPI CD/DVD-ROM drive
hde: IBM-DTLA-307045, ATA DISK drive
hdg: IBM-DTLA-307045, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xd400-0xd407,0xd802 on irq 11
ide3 at 0xdc00-0xdc07,0xe002 on irq 11
hde: 90069840 sectors (46116 MB) w/1916KiB Cache, CHS=89355/16/63,
UDMA(44)
hdg: 90069840 sectors (46116 MB) w/1916KiB Cache, CHS=89355/16/63,
UDMA(44)
Partition check:

(tento vypis neni ten originalni - ten jsem bohuzel poridit nemohl)

... a zustal dlouho chrastit disk (pricemz skoncil na polozce Partition
check). Nechal jsem ho asi 3h a nic se nestalo. Pote jsem ho odpojil a
system v poradku nabehl. Disk je typu FAT32. Nevim co se najednou stalo.
Muze mi to nekdo nejak vysvetlit? Pod WIN X jede uplne v poradku ...

Diky PetrR

P.S. Asi nejlepsi by byl format disku (ale kam dat data?)