usb dvdrw na WB30 neni videt

[Honza E]

Dobry den,
mam MSI MB se dvema opterony a bezi tam WB3.0.

Dostal jsem usb DVD vypalovacku TEAC DV-W58GA-PUK
a system ji nevidi (viz vypisy dole)

Na starsim stroji s RH7.2 po pripojeni okamzite 
(po natazeni modulu) bez potizi nabehla.

Je chyba nekde v nastaveni BIOSu, HW, jadru_ve_WB,
na zidli u klavesnice (asi to posledni, ale co je chyba -110?)?

Dekuju a preju hezke prazdniny tem, kdo je maji!

Honza

...
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
hub.c: new USB device 00:10.4-4, assigned address 4
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=4 (error=-110)
hub.c: new USB device 00:10.4-4, assigned address 5
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=5 (error=-110)
hub.c: new USB device 00:10.4-3, assigned address 6
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=6 (error=-110)
hub.c: new USB device 00:10.4-3, assigned address 7
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=7 (error=-110)
[root na opteron honza]#


[root na opteron honza]# cat /proc/scsi/scsi
Attached devices: none


....
Jul 29 16:30:44 opteron kernel: usb.c: USB device not accepting new address=4 (error=-110)
Jul 29 16:30:45 opteron kernel: hub.c: new USB device 00:10.4-4, assigned address 5
Jul 29 16:30:50 opteron kernel: usb_control/bulk_msg: timeout
Jul 29 16:30:50 opteron kernel: usb.c: USB device not accepting new address=5 (error=-110)
Jul 29 16:31:11 opteron kernel: hub.c: new USB device 00:10.4-3, assigned address 6
Jul 29 16:31:16 opteron kernel: usb_control/bulk_msg: timeout
Jul 29 16:31:16 opteron kernel: usb.c: USB device not accepting new address=6 (error=-110)
Jul 29 16:31:16 opteron kernel: hub.c: new USB device 00:10.4-3, assigned address 7
Jul 29 16:31:21 opteron kernel: usb_control/bulk_msg: timeout
Jul 29 16:31:21 opteron kernel: usb.c: USB device not accepting new address=7 (error=-110)
#--------------------------------------------